Threaded Pipe Fitting

I needed to split the output of the foot pedal for my HF blast cabinet so I could feed the k/08 pneumatic shaker, but only when the gun is in use. This did exactly what I needed it to do. I've customized my cabinet all the way around and this was the final puzzle piece.

Working as of now no problems used on air compressor

Good fit

As the title says, this fitting is well made out of solid brass. Treads are clean and sharp.

Should do the exact job I need it for. You'll never find this at a store locally. I bought this for my trucks 3gal air tank. I already installed a tee, with a ball valve. This is to put on a drain valve, to remove the rusty water from the tank every once in a while. The other end is for a air hose coupler, after the air valve. The threads on this tee are good, and it has thick walls. It's brass, not steel,with plating either. I'm pleased, and would buy again if needed.

Allowed the addition of a mechanical oil pressure gauge.

The fitting is rectangular, which makes it easy to install.

Used it to tee off my oil pressure sensor in my 2009 mazdaspeed 3 so I could run an oil feed line to my turbo (duratec block 2.5L).