PROGRESSIVE AUTOMATIONS Industrial Linear Actuator Stroke Size 22", Force 2000 lbs, Speed 0.33". sec - 12 VDC (PA-17-22-2000)

The media could not be loaded.  This is really great everything went together smooth and works great so far... we'll see how it goes.

The media could not be loaded.  Just awesome! Built a draw bridge for my deck. Another brand of actuator just wouldn’t get it done. You MUST use a 24 volt power supply!

This PA-17-6-2000 is just right for my 2016 John Deere TS 2x4 Gator. The most difficult thing was adjusting the limit switch. Just watch the YouTube video, be patient because it may take a couple of times to set the limit just right. The small limit wheel sits on teeth. Move it 1 tooth = 1/8 inch. You will likely only need to adjust the max limit which is the top wheel. Great product! Saves me from a lot of exertion.

I ordered this unit not knowing whether or not it would work. Let me say, with a little imagination and mechanical know how, it worked better than I had hoped for! Grasshopper wants over $800.00 for an exact replacement. I was able to reposition my front bracket by 2 3/4" forward and this unit works great! I just want to say Thanks!!

The specs on the product and it’s performance have been very good.However, if you are designing and building be aware that you are flying without a safety. The product is easily powerful enough to break itself. One of my unit has begun to fail due a design mistake on my part. An unexpected edge case occurred where the angle between the motor housing and ram cylinder changed. Now the motor drive gear is worn and failing.The device is designed and built in a serviceable fashion, but there are no replacement parts were available. If parts were available, cylinders would be great.Minus 2-stars because at the price sold, repair should possible.

Used on a custom fabricated motorcycle lift with high strength aluminum frame. Total weight 450 pounds. Failed to function (burned out) after 30 days, less than 50 cycles.

The pa 17 with a 8in stroke and 1/2 in holes mounted up side down will fit perfectly into a 2019 570 mid size ranger dump box.Pull the 2 pins on the factory tilt strut and reuse them on the pa 17 to install.Hook up your 12v thru a heavy duty switch or for 25 bucks, run it thru a wench solenoid controlled by a switch like i did. Adjust the limit switchs for precise control of when unit stops and your ready to go.Works great.

Very nice. Im using this in a severe duty application on a sleeve hitch for an ATV blade. It holds the blade firmly against the ground and could even lift my ATV off of the ground as well. Worth the money!

I ordered a 850 lbs 2 " labelling on the box was correct but the actual product was a 450 lbs 4" lift. Will update rateing when everything is corrected

J'ai acheté le produit pour remplacer mon actuator sur ma pelle à neige. J'ai demandé la dimension extérieure du mien soit 16 pouces. Le mesure ne correspond pas avec celle reçue. Je crois que leurs dimensions sont la longueur de l'ouverture du cylindre.Je suis déçu car celui reçu est beaucoup plus robuste.

Excellent product. Delivered on time as usual. Thank you Amazon you people Rock, good job!

Works very well. Using it to lift a 70” tv.

fonctionne très bien