Taiss 2pcs RV24YN20S 2K Potentiometer Single Turn Carbon Film Rotary Taper Potentiometer Used for Inverter speed regulation. Motor speed control + 2pcs A03 knob + 2pcs dials (B202 2K ohm)

One of the metal machining mills at work was very inconsistent when adjusting the spindle RPM. I noticed a crack in the housing of the potentiometer. So I ordered these and replaced it. It took care of the problem. Seems to be made well and operates properly. Worth the price and easy to install.

They work well, got me back on the road

Very nice for the K40 solid build wish the terminals where thicker they all seem on the flimsy side... not just this one but every one I have come across must be the norm on these POTs Nice beefy fell to this one (OHM gadge as well that you can actually read)

OE mft sent one that did not fit new replacement face plate (too short no thread area). The Taiss RV24YN20S fit perfectly and also performed to spec. Easy to recommend!

Good quality potentiometer for feed rate or Vfd. Packaged in a pair so enough for a project or to replace worn ones. Had issues with feedrate stuttering and stalling and it was a bad pot. The spindle motor was surging 100-250rpm and also a bad pot. When it comes to cnc control you need a reliable signal and 50k pot works very wel for some applications. Be sure to check your requirements first but if you need one than this is it.

I bought this variable potentiometer to build a speed controller for a DC treadmill motor I am using on a drill press. This unit works perfectly for that purpose.

This works but don't expect too much here.The Knob is vary loose on the shaft. I did not expect the knob would stay tight so being a machinist, I carefully clamped the shaft in my mill vice and used a tiny 3/32 carbide end mill to cut a flat in the proper location so the knob will stay properly clocked so the line is placed at the far left and proper angle for the beginning of the sweep from left to right.I just assumed this knob would use an Allen screw, no, it requires a tiny flat blade screw driver. I was ready with a selection of tine flat blase screw drivers, but would much prefer Allen head screws.It does properly operate my VFD speed control for my old Bridgeport mill but 75% of the travel does little then in the last 25% the speed climbs from a few hundred RPM to 1150 rpm. Not sure the cause for this, my VFD does call for a 5k pot, but no matter, I have adjustable speed for when it is needed now.~

One was 100k the other was 75k

I added this device to control the volume in a grandfather clock. Works really well.

Es exactamente lo ofrecido y que necesitaba como refacción, no lo pude conseguir en ningún otro lugar masque en Amazon!!Funciono correctamente.

todo indica que los potenciometros de tipo resorte, ya no existen, solo seran de tipo laminillas rosantes y tipo platino, solo verificar dimensiones del cuerpo antes de ordenar, la resistencia es la misma.

Comes with a decent quality dial which can be clocked any direction. Tested the resistance with multimeter, it is accurate to its specs. Didn't realize it came with 2 sets! Big win!

It works like a champ.