Louisville Ladder Flipper Replacement Kit PK105, Black

For non-Louisville ladders, check the size you need. The flipper needs to reach from the axle point all the way to cover the "toe" of the foot that will sit on the rung. In other words, if it's too short, it will be just like having no flipper at all. These are 2 3/4" long, whereas I needed 3 1/8" for my Columbia (discontinued) ladder. See photo. I guess I will try the 3" ones here on Amazon, and see if they fit. These didn't work for me.From the axle hole, these extend 2 3/8".

Very disappointed that the parts sent to me didn't work as they were the wrong parts. But, even the manufacturer of the ladder couldn't provide the right parts. They advised I should just replace the ladder. They won't stay in business with that attitude.

I purchased these replacement parts for a ladder I've had for close to 25 years. They were a perfect fit and the repair was simple. In short, I am completely satisfied!

it was a little hard trying to figure out the instructions, but i did get it on and it did work somewhat. I did use it but it sometimes got stuck and flap would not always close.

Value for money,You have to use a drill to remove the old oneAfter that they fit like the originalMy ladder is a 28” Louisville

Not much to say about item other than the original ones on the ladder broke and these are exact replacements. In my case the original flipper was riveted into place so I had to drill it out (took 1 minute), then took a few minutes to install this item mainly just trying to get the spring in the right place and I was back in business. Used this winter to hang the lights (and take down) and help the neighbors hang lights and held up just fine with more than average home use with no issues

These flippers fit well and allowed me to continue important gutter work after I broke the originals .

This was very easy to install and works as expected.

Good