Voswitch UV100 8 Gang Programmable Switch Panel Power Control System for Truck UTV Side by Side Boat 12V Battery Use

I have a 2016 Sierra with several additions including an auxiliary battery, winch, front and rear LED lights, and an air horn. Hey, I’m from Alabama what did you expect? I quickly ran out of space for switches on the dash, and did not want to cut any holes in it either. There was also a large number of extra wiring harnesses, inline fuses, and relays. I decided to install a switch panel that integrates everything in one panel. I needed one that can change colors to match my red dash lights, dim, and also have the ability to make the switches momentary, you know, for my air horn! There were a ton of different kits out there, but this was the only one that offered all of the features I was looking for. It also included a pre-populated waterproof enclosure that came with relays and fuses.The kit came very well packaged and with all necessary installation items. I was able to mount the panel to the same spot I previously had my switches installed. When you install the unit, just take your time and pay attention to the directions. I used wire loom and created a new harness for the wiring from my accessories to try and keeps installation as clean as possible. When done, I had eliminated a big wad of wires from under the hood and have only a single control cable going into the cab which is not visible. When you look at the pics of under the hood, the red wire that is rolled up is the remote turn on wire that hooks to a circuit that is on when the ignition is on. I currently have it installed using the power switch on the panel to turn it on and off. I ran out of time to run that last wire and will address that in the future. The relay box has a set of dip switches that enable either manual on/off or on with accessory power. Either way, the unit can be turned off with the power switch on the control panel and will remain off until turned on via the switch. I hope this review helps.

There is NO REASON to spend over $1k on a switch control (that is just plain stupid). However, you also do not want to trust the power distribution of your high end off road rig to a cheap knock off (fires happen often due to bad vehicle wiring components). There is a certain brand that many are buying and I just wonder how many shorts / fires will happen. In addition, who thinks solid-state relays are a good idea? if the board goes, you have to throw away the entire system and start over. Relays go bad and are dirt cheap to replace. I wanted a simple switch controller with "REAL" realys and Voswtich had it all. Great quality fit and finish and real relays. This is a great system!

I had this sitting on the bench to install for a couple years. By time I opened it I noticed what I thought was a protective plastic peeling off. But it is actually the panel itself coming apart.It works great. I really like that it has low battery protection, multiple modes, and multiple colors. Being able to adjust the brightness is nice as well. Install is easy.

I wanted to find a minimally invasive solution to installing switches into my 2007 Silverado LTZ. I was not keen on wiring rocker switches into the cab and drilling into my dash or console, so I began what ended up being a long investigation to find a high end, neat solution that would allow me to avoid this.Most solutions required extensive wiring inside the cab, or looked cheap, so I continued crossing off options from my list, and adding others but I kept coming back to this unit.The Voswitch UV100 8 Gang is a robust unit with a metal switch plate requiring the connection of the switch panel to the wiring harness with one single connection through the firewall. Although expensive compaired to other solutions, I believe it is the only product that will provide me with the clean look I am looking for.I plan to mount the switch panel on the A pillar using a pod mount and adaptor and should give me the neat look I am looking for.

I had several small switches drilled into the dash of my truck. But they were only rated at 5 amps. I always worried about causing a fire. And they were hard to label and identify at night. I started building a relay box of my own and that quickly got expensive. This thing is convenient and looks a lot better under the hood than the 8 inline fuses attached to my battery + and the big wad of grounds. Was able to remove big bundle of wires going into the firewall/under the dash.At the same time I ordered this, I ordered a prewired 6 switch box with no relays. I looked at both of them when they arrived and gladly installed the Voswitch. Quality is great. I mounted mine to the top of my 24v Cummins.

Great value for the price. Super easy to install. I fabricated my own mount to move it to the A pillar of my 2017 Jeep JKUR, but the different mounting brackets that come with the kit give you many more options then some of the more expensive brands out there which makes the price even more amazing as you get more then you’d expect. I know this company is coming out with a JK specific version of this product soon from what I hear. I did end up having a minor glitch with the switch panel and this company totally stood behind their product and made it right and got me the replacement part free of charge and in a very timely manner. Customer service means a lot to myself and my friends I wheel with and this company has shown me that they definitely have that!