Equalizer Plug and Play Load Equalizer and Stabilizer for Harley Davidson Motorcycle LED Turn Signals

Arrived quickly, but most important is that it fixed the issue as described. Easy to install, I just had to move some wiring around to make everything fit.

Solved the hyper flash and was easy to install. My 09 road king had been upgraded with the rear turn/brake/run light module and after upgrading to led turn signals front and back, this equalizer was completely plug and play even with the other harness for the upgraded rear turn/brake lights already installed. Exactly as advertised, easy to install and works great.

Work like it should

Got the equilizer is September, but couldn't install it until late October. It is super easy to install on the Dyna. Go under the seat and plug it in. When i got in and put tue LED signals in i got the MIL light on next to the speedo. Looked at everything and found i had no turn signals in the rear, no brake and no tail light. I am using an LED tail light and the only that worked was the tag light, that flashed when i tried to use turn signals. Went through a troubleshooting process and pulled the equilizer out and everything worked fine. I tried to contact the seller about a replacement and couldn't find a way to do so I'm out the 70 bucks for the equilizer. Just a buyer beware here. For what its worth i ride a 2011 Harley Superglide. You're mileage may vary, but i would be careful buying this one.

This worked great on my '03 bagger. I did have to straighten the pins as suggested in the instructions, moved them in towards the center. The plug slipped right on then.

It works just as it should. It slowed my blinkers down just as it should no more hyper flash works awesome. This company makes awesome products for all your biker needs.

I had previously installed an Eagle lights strobing LED taillight on my Softail. I wanted to continue to use my H-D turn signal module that makes the signals also work as brake and running lights. That module no longer worked right after installation of the strobing brake light. Even though you don't need a load equalizer just for the taillight I decided to add one anyway to see if it would solve the problem. Good news - it did. Now I have the strobing brake light and the auxiliary lighting. And FYI, the turn signals have incandescent bulbs. So even with mix of bulb types this works. Thank you Eagle Lights.

I have a 1999 fat boy and the signals worked, but they wouldn't auto cancel and the indicator lights in the dash didn't blink. I installed this today and it fixed both problems. I had to tweak the pins a bit on the load equilizer for it to plug into my harness, but other than that, it was an easy install. After testing the hazards, they're stuck on and either turn signal button makes both sides blink. I don't think it's this module's fault, just a weird glitch in the TSM. I'll disconnect the battery tomorrow and see if that resets it.

I installed it on Fatboy low 2010 because I got hyper flash when I install LEDs turn signals I thought this device going to solve the hyper flash and the key symbol on the dashboard it solve the hyper flash and turn off the key symbol on the dash, but my security alarm start to be weird if I turn off the motorcycle and stand beside it it will not close the security. make the turn signal flash every five seconds for no reason I don’t recommend it.

Works as described . No heat

Parfait fonctionne bien Reste juste a savoir si ca va toffer

Works perfectly for my 2009 Harley Davidson Electra Glide.

GETS RID OF THE ENGINE CODES WITH NO HEAT BUILDUP