GUAIMI Motorcycle Turn Signals Front Rear LED Indicator Lights Compatible with Tiger 800/XC Tiger 1050 Daytona 675/R Speed Triple 1050/R Street Triple 675/R Daytona 675 Daytona 675R

Will require spicing but very easy to install. Make sure you get LED load resistors or a new fuse to eliminate the fast flashing. TST Industries makes very nice plug and play products to fit most bikes.

The nub that houses wires that goes into fairing is not made for Triumph it is a BMW fit. It has a pultruding part that needs to be shaved off and the circumference is far to large to fit in fairing hole - it also needs to be shaved down and not as easy to do a good job of it as it sounds. Also, the distance from the bolt hole to the wire hole is slightly longer than Triumph set up - again it is a BMW setup. I was able to cut it down but very disappointed. The ad. mentioned being sequential but it is not. The base is hard plastic and has no bend to it like original Triumph - could be a problem if bumped into hard.Ok. so what does work. It is led and they do work - front plastic has slight tint to it which i like - wires have protective sleeve over them which is very good ( many cheap after market ones do no have this.Overall would I buy again. NO - but they are installed and they do work. Although led's could be brighter....Note if this was for a BMW I would have given it 3 stars, down stars because of hard plastic base and could be brighter led and not sequential

La luz es funcionan como se espera pero la motocycleta tenía hyperflash con estas luces

The lights were advertised as being a direct fit for my 2007 Triumph Tiger. They were not a direct fit. They look great would have been exactly what I wanted but would have taken too much modification to the light or the bike.

I went through getting all the wiring connected only to find out that the signal light itself does not fit into the notch on the tail piece of my 2011 Triumph Daytona 675, which is one of the specifically advertised compatible bikes. Waste of time and money.

Almost fits but no dice ! 07 tiger 1050. Just drill the fairing. Looks better than stock and works.

While this item look quite similar to the factory original. Beware of three major differences.1. The wiring connectors are not compatible with the factory original. I cut the connectors off and put on the ones work. Item is no longer return-able.2. The mounting base is slightly different and needs to be trimmed off to fit on the bike. This again made the item not return-able.3. LEDs do not draw the same current as the conventional bulbs. This causes the flashing rate to go up from the original turn signal rate to a very nervous three times faster rate. Solutions exist but not part of the kit.I felt that I wasted my money and my time, chasing an upgrade/update. I put the old lights back. You decide for yourself.

These are hard plastic, they do not fit a Tiger 800 XC without modification.

El producto es de excelente calidad sin embargo no le quedan a la triumph Daytona 675r como promocionan.

if old style bulbs are present on bike and LED's are being installed, capacitor will need to be installed for each turn signal or a new flasher installed to replace OEM. this will eliminate the high speed blink. Also wire connectors do not match OEM.