HPS Performance Stainless Steel T-Bolt Hose Clamp Size # 68, fit 2.75" ID hose SSTC-76-84 Polish 2.99"-3.31" (76mm-84mm)

I've bought and tightened about seven of HPS t-bolts with no issues for my 2015 Subaru WRX STI Process West intercooler, but on one of these sizes, it snapped while I was tightening it. Make sure to wear goggle safety glasses while tightening these! The broken end went flying and I'm lucky to not be injured. The ones that are installed are working well for one run so far. Let's see if they hold up.Amazon is sending me another one quickly at least.

Replaced the Subaru OEM TMIC to throttle body hose that fails quickly with the new Mishimoto and these clamps. Regular clamps would fail as it couldn't get tight enough and read the T-clamp was a better choice.It was a little tricky getting the clamp set to be able to tighten down but used a long extension for the socket and got the job done. The wide body design and being able to secure the hose made me feel better about the car overall. I believe I had a bit of boost leak because of this. In either case highly recommended product!

I believe these clamps are meant for rubber hoses, coolant or intake hoses. I've seen them used on motorcycle exhaust though and decided to give them a shot on my car's exhaust.There is no way for these to clamp sufficiently to crush the exhaust tube so slots must be cut into the outer tube. In my application the slots were precut in the tube at the factory. These clamps allowed sufficient clamping force to securely clamp the slotted outer tube to the inner in my exhaust system. They look much better than a regular exhaust clamp and do not distort the tubes allowing disassembly in the future.

the clamp was well made and strong. But the description was wrong. Make this clamp as small as possible and no way it will be tight enough on a 2.75 OD inch hose. I ended up ordering the next size smaller and keeping this one because it was not too expensive and very well made. The smaller clamp was perfect.

Worked great. Good price.

Good fit for intercooler piping.

Great quality, clamps hard. Used to replace the OEM worm clamps on my intake system (turbocharged car). I feel better about having these in place than the OEM, especially during reinstall using performance parts.

Quality stainless clamp

I used this clamp on a Dodge Stealth twin turbo, to connect the intake to the manifold. It's working great, it clamps like Clamps from Futurama and no issues with the pipe popping off.

Perfect

Perfect