Sloan Flushmate BU-100505-K Upper Supply Kit for all series

Fit flushmate 501a. I cut the upper hose clamp with my dremel and heated the hose with hair dryer to release it. Everything worked perfectly. Original factory part

Perfect match and installation on my toilet. This part did NOT fix the problem, but that wasn't the fault of the part. If you're having trouble, check your tank itself for pinhole leaks. With some soapy water, I found a tiny, tiny bubbling leak near the top of the tank that was slowly leaking out all the pressurized air. So over a couple days, the toilet would stop flushing properly until I bled it down and started again. So the problem may be something other than these toilet parts. In my case, I dried everything and patched the area with JBWeld.

My parents had a plumber say they would likely have to order parts that would be a lot. Well, I couldn't believe that as it had just been working fine but was moved for some drywall work and put back. I had reset the tank before by shutting the incoming water off, flushing, etc and was able to get it going, so had some exposure to it. They said it was leaking, so I looked and it appeared to come from this supply valve. Apparently, this has a small rubber duckbill [Flushmate Duckbill Valve (Air inducer) - I may have been able to just replace it directly, too.] that may degrade over time. I ordered and replaced this easily and it worked fine. It did make a whistling noise for a bit, but pushing this assembly a little off line stopped it and it hasn't come back. The toilet is working fine and it has been several months. Next time, may just need to replace the duckbill. It looks to be the real wear item here.

Took 5 minutes to install and works great no leaks. If your hose has a compression clamp I suggest loosening and cutting it off, the hose in mine was short enough and cutting it like the instructions suggested would have made it too short.

So happy I was able to find this replacement part. The little plastic nut on my mine cracked causing water to leak into the tank. (Not Good) I thought I was going to have to replace the whole toilet and was not looking forward to the project or the expense. Found this kit and was able to use the new plastic nut as a perfect replacement! Very happy!

This little item and Amazon's quick delivery pulled my bacon out of the fire. I've had Sloan Flushmates installed for 20+ years and this was the first problem. A plumber suggested that I might have to replace the whole system to repair the problem. I did some research on YouTube, ordered this part, and installed it myself in minutes. I believe I saved hundreds of dollars by doing this.Good product, good service, perfect result!

I had no problem installing the part. It took about 20 minutes. Cutting the old hose clamp took the longest time in the instructions it says to just cut off the hose, but I wanted to keep the hose the same length (didn't have to there was plenty of slack). Also make sure to turn off the water at the toilet before you start.

The part leaked

Muy buen producto