upHere Graphics Card GPU Brace Support Video Card Sag Holder/Holster Bracket, Anodized Aerospace Aluminum, Single or Dual Slot Cards (Black)

For all of you with long GPUs out there, this simple brace will not only improve the aesthetic of your PC but also prevent long term damage of your PCIe Slot. Highly recommend!

Does it's job very nicely and the delivery was also excellent and on time

Would very much like to buy this.. but looks like very inflated right now, Hopefully it will come down in price and I could buy it around 1k

The bracket design is sturdy and looks good, but it has a critical flaw; the rubber piece meant to sit on the bracket and support the GPU is off-dimension (see the huge gap in the picture attached). As a result, it fits loosely on the frame and causes a lot of trouble during installation. This is a result of poor finishing and is quite unfair given the very high price.

This product is great, only a week in but i'm confident it'll be good. It was a bit of a pain to install in my 4000X with a 4070 super, but I got it in the end

Il prodotto ha perfettamente soddisfatto le nostre esigenze! Ottimo grazie.

Work fantastically well in my Lian-Li o11 Dynamic. I have an MSI armour RX 580 pc and it supports it well and was easy to set up. Looks great too. Worth. Every. Penny.

Arrived quicker than the expected date by a week (because of a lack of orders due to the COVID-19 crises) and it was decently simple and quick to set up. Looks good and I like the logo/brand name printed on it.

TLDR This bracket will support even a 3 slot GPU. It will do the job well and it is sleek enough to fit in any build. It is a simple GPU support bracket that holds the weight of my ASUS TUF 3090 well. Due to the cut outs for the screws being slotted instead of just holes, you can adjust it accordingly. You will have to use the screws provided in order to secure the bracket. As for me, I did not like the logo "uphere" smacked dead center on the bracket, so I turned it upside down and installed it on the unused PCIE slot covers. There is no logo on the other side. I believe it being upside down shouldn't cause a concern even if said PCIE slots are being used. Just make sure you have 3 PCIE slots below your GPU, if you're installing upside down. It is tricky to install if the tower is standing, so I suggest laying it down on its side so the GPU is sitting up. You can then pre-install the bracket just enough for the screws to be partly threaded in. Level your GPU and the bracket until straight, then fully tighten the screws. It's cheap, simple, and does the job. I don't see anything bad about this product during the time of writing.