LET'S RESIN 19 Styles Dice Moulds Set,Polyhedral Game Dice Moulds 3D Silicone Moulds Different Sizes, 2-Part Epoxy Dice Moulds for DIY Table Games, Board Games, Role-Playing Games Dices

Not a bad product if you are just beginning to dabble is dice casting like myself. The main thing is that one of the D10 molds has already ripped. It came with what looked like a slight defect in the silicone, but the reat looked fine so I continued to use it. I was able to make about 4 sets before it completely tore on the 4th set. I am hoping to get in contact with the seller so I can simpmy replace the D10 mold. The only other downside is the caps are difficult to set without too much epoxy runover. This is not necessarily the sellers fault, just a symptom of silicone cap molds.

Title says it all - ordered some time ago and tracking says your parcel may be lost

Okay so I gave it 4 stars because despite not having instructions after you figure out how to do these they are actually nice. The bad thing is you need a dropper and you have to click one side into place. So you’ll start to fill it, then put the single side on then fill it the rest of the way with the dropper. This is the only way I have found it will take and fill up that side. If I don’t do it this way then that one side that has to be added on doesn’t come out with the number & is very rough. So for easy to use it’s not 5 stars, easy to clean yes. Durability 5 stars, these molds are meant to be turned inside out. Not one has ripped on me yet. Overall it’s a nice set but there should be instructions and perhaps better packaging you’d think so for the cost. I’ve seen cheaper sets here on Amazon for $10.00 these were close to $20.00 when I bought them so I expected maybe something with instructions and more closed than how these are with the sides. Overall after fingering them out they are a good set, just maybe check cheaper ones too might just be the same thing sold from another company.

Would've been a 5* but there's no percentile dice for the larger set :(

Perfect product! Each mold is packaged with it's corresponding lid, so no need to match them up when you receive them like I had thought previously. Good size, not too big not too small. And a great variety with 19 molds in all.Update 1/19/21The lids are all numbered on the wrong side. I will have to trim each one if I want numbers that correspond correctly on each die. The lids all have a beveled edge with a hole to let out air bubbles and a small thin notch to hold onto. That will all need to go if I want the embossed number to embed in the resin correctly. Maybe the manufacturer should rethink the design altogether.