Auxbeam 5 Inch LED Light Bar, Side Shooter Pod Lights 30W Spot Lights Driving Lights Compatible with Jeep Wrangler Motor UTV ATV Offroad Vehicles (White Beam)

Love them!!

Like many Jeep XJ 's mine was not equipped with OEM fog lights. Searched forever for a decent set that would fit the factory "knock-outs". These fit perfectly!Wiring harness, as others have mentioned, is well made and very easy to install. They are quite bright, have a decent coverage pattern and the "side-shooter" feature does put a good bit of light off to the sides of the road.Not a light that you'd want to leave on when meeting other traffic.I'm going (tentatively) with 5 stars. I've had other Auxbeam lights in the past that have not been water tight. They did replace those promptly so I'm cautiously optimistic.Recommend purchase, especially if you have a unique mounting location like my Jeep XJ

Muy buena calidad y excelente producto los recomiendo.

Seems good. However I have to question the size of the fuse it comes with. It comes with a 30 Amp fuse but only draws just 4 Amps according to my measurement. I'm pretty sure its cable harness would fry before the fuse would blow. I replaced the 30 Amp fuse with a 5 Amp fuse.

Using these as reverse aux lights. Don't need them for daily. More wanted these than needed them. The light output is good and the quality is also good. The harness was not long enough for my installation but it understandable. Its a full size pick up and needed to run the harness from all the way rear bumper to engine bay.

These lights were purchased to mount on the front of my truck and supplement my stock lights during fog or snow.Pros: Lights came well packaged and had complete wiring harness. The harness included an inline fuse, switch for the interior of the vehicle, leads plenty long enough to reach the lights and everything was tied together with a 40 Amp relay.The light pattern is the same on both lights. And the yellow tint is consistent between the two.Cons:The quality control on these lights is lacking. There are holes on each side of the lights body that a screw passes through. These screws are how the up and down adjustments are done. This would work but on one of the lights the hole is at the wrong angle and I can't even tighten up the adjustment screw all the way.The ends of the wires coming out of the lights aren't finished to plug into the provided harness. It would've been nice to at least get correct connectors loose in the box.The lights put off a ton of EM interference and mess up both the AM and FM radio reception. I'm going to try some ferrite cores on the wires to see if this helps.Instructions were extremely lacking and had no info that applied to the side shooter lights. And no instructions on wiring.I will keep this lights installed to see how they perform. If the QC and instructions were better these could be an awesome value.

Pésimo envío llegó mojado y no funciona, llegó totalmente mojada la caja y el producto

Not used in fog or snow yet. Lights appear to be quite bright which isn’t what you always want in fog/snow so I guess I’ll see how well they work at some point. Definitely will be useful off road with ditch lighting and added illumination.