Compatible with GROM MSX125 SF 2013-2020,LC150 Exciter150 INCH BILLET REAR SHOCK LOWERING SUSPENSION (BLACK)

If you getting this for your grom clone be aware that it will work but only with some modification. You will either have to drill the bolt holes bigger or bench grind/sand down the bottom of the black block. After its all said and done the bike does sit much nicer and way closer to level. Helps give that dirtbike/pitbike feel for sure.

The lowering link works with stock swing arms but you will have to grind 1mm off the bottom of the black piece. Has no instructions so you’ll have to figure it out but it is pretty easy. The red pieces have to be installed a certain way, which you’ll also figure out through trial and error. Lowers the bike about 2 inches. I would probably recommend this.

The product did not fit the stock swing arm of my 2020 grom with a little modification to the product. It appeared to be to tall and the bolt holes are so snug that the bolt would not go through. I had to grind off a little bit of the bottom to get the bolt hole to aline just right. After that the bold still would not go all the way I believe due to the powder coating on the swing arm. Used a little mallet was able to start it and then just used the wrench to turn and push it the rest of the way through. Everything seemed to light up after that with no issues. Did 2 2020 groms the same way. The second one was done in 30 mins since we knew what had to be done to make it fit.

2015 Grom fits no grinding no issues

As other ppl say, the base part is about 2mm longer than stock.If you have machine tool like a disk sander or a belt sander this is not really big deal but like me, it was very hard to sand by hand.Solid and looks nice.It really depends on tools you have.

Works like a charm easy to install. If using on a clone you will need to grind down of the main bracket