Uncle Mike's unisex adult QD 115 SG-4 Blued 1', Clam Magnum Band Swivel Single Over Unders, Black, 1 US

works as it should

The swivel stud was easy to install into the wood stock of my Stevens 555 Compact over/under 20ga. I used both a 5/32 drill bit and 7/32 drill bit (countersink) to install it. I drilled 1/8 inch deep using the 7/32 (countersink) and then 7/8 inch deep using the 5/32 in the center of the first hole. Then I put a drop of wood glue on it and screwed it in. Screw it in the stock slowly so you don't split the stock.For the barrel end, I applied a bit of medium threadlock on both screws. it can be a little tricky getting the screws on the barrel-end swivel to thread initially but be patient and don't crank on it too hard or you could strip them out. Just take your time.

I got it for a tristar over under 20ga, perfect fit and stays in place when using Uncle Mike's gun tite.

This swivel set is just what I need. The instructions explain how to proceed. I have ordered Uncle Mike's Gun-Tite for a good lock onto the barrel as recommended. It is the correct choice for this application IE. 0.70-0.75 for my 0.73 fit. Some reviewers seem to claim it is easily stripped. I say, be very gentle as a snug fit is all that is required. It is for my New England Westinghouse 30-06 Bannerman Sporter 1918. It is US made like a Mosin made for Russia before WWI. I am very happy with its use. Since the barrel was turned back a bit it lost the serial # but the Bolt has it, However there is no way to know if was the original one. I intend to use 3/4 loads from my reloading bench for this old Workhorse. The date for the bolt SN. gives the 1918 date as above.

They were a little (not a lot) tricky to get the tiny screw in to hold the barrel side swivel. I wish the screw were a little bigger.

Good fit for Savage 24v 20 ga barrel

Sold to a different company. Zero representation. Sizes are always wrong now with NO answer.

Product was as advertised, easy to install instructions, seem to be of good quality! Have been using on my rabbit hunting gun this winter, very satisfied!

Conforme aux spécification du fabriquant et ne prend que quelque minutes à installé.

OK I needed two sets of shotgun swivels one for a 12 ga and one for a 20 ga tried to get both in Uncle Mike's as name brand little more expensive so figure should be better quality. I could not get the correct size clamp for the 12 ga so ended buying the Tri Rock set for it at $7 less. Guess what the Tri Rock are much better quality they fitted easily no problems. With the Uncle Mikes there were sharp edges on the screws which I filed down and one of the swivels was a bitch to attach could not open it the spring loaded screw to open the swivel would stop before enough clearance had to force it back all the way so issue with thread I have attached it now and will leave the sling on as will probably fail if used a few times. Only thing better on the Uncle Mike's was the instructions Tri Rock none but if you've done these before they are not needed.