Are the plastic components made from abs? i am curious about using this for air circulation for an acetone vapor bath for 3d printed parts

I don't know what kind of plastic it is made of but the acetone does not seem to melt it. Tried a rag and some acetone on the housing and the blade, no plastic came off on the rag. Can't say the same for the wires, they did somewhat dissolve with the acetone. And the way the air flows, it will go over the wires which are slightly exposed in the wire channel.

will this work for replacing a .11 amp fan?

If it is the same physical size, and the CFM requirement of your device is met, then yes. Air flow would be the critical factor. Since it draws less current than your original, you should have no problems. This assumes you are driving it with 12V.

Brand	ANVISION
Power Connector Type	3-Pin
Voltage	12 Volts (DC)
Cooling Method	Air
Noise Level	27.5 Decibels
UPC	611434680760
Manufacturer	ANVISION
Model number	AN-YDM4010B12
Item Weight	30 g
Product Dimensions	3.99 x 3.99 x 0.99 cm; 30 g
Item model number	AN-YDM4010B12
Item Height	0.39 Inches
Item Width	1.57 Inches
Auto Focus Included	No
Are batteries included?	No

ANVISION 2-Pack 40 x 40 x 10mm 4010 Dual Ball Bearing DC 12V Brushless Cooling Fan UL CE YDM4010B12

التفاصيل

الوصف

المواصفات

الأسئلة الشائعة