I have a jjrc h36 I’m going to direct solder to the board. what is the proper motor configuration?

If it runs on Betaflight then its bottom right is motor 1 (clockwise), top right 2 counterclockwise, bottom left 3 counterclockwise, top left 4 clockwise, all while having the drone face away from you.

will these spin if connected directly to a DC power source or is a controller board required?

If you need to be able to control the speed, you will need a controller of some kind. If you're a hobbyist, there are some NE555 circuits you might find online to provide a PWM (pulse width modulated) output to the motor. There are some Arduino boards that might work as well (which might be easier to build and program).

Will these work on the Furibee f36?

Yes but you have to solder 1.25mm JST Plug female plugs on the flight controller or cut and solder the wires. Other then that they work fine

Do these motors work with the e011 board?

They do work with the board but will not fit the motor mounts of the e011 frame. They do fit the frame of the e010c because that's what I did. I put the e011 board with these Crazepony 6x15 motors onto an e010c frame (because the motors are soldered to the board) that I had as a spare. I think the motors for the e011 are 7x16. These motors work great in the e010c frame in my opinion.

Voltage	19000 Volts
Speed	70000 RPM
Item Weight	2 Grams
Shaft Diameter	0.8 Millimeters
Material Type	Rubber

Crazepony

التفاصيل

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة