Double Sided Universal PCB Prototype Soldering Circuit Board - 15x20cm (4 Pack)

Great boards! I use these mostly with ATTiny84 projects. I can cut the boards in half and have room for most of the circuits I have made lately. The size is perfect. They are durable little boards. I have never had an issue using these. They are very well made and easy to work with!

I use these PCB prototyping boards for an esp32 project seen here. They're very easy to use and easy to trim. Looking forward to using them on future projects. With soldering flux, these boards are very easy to solder.

Picked these up for small electronics builds and they’ve been working great. The boards feel solid and not cheaply made. The pads are clean, isolated, and well defined which makes soldering a lot easier. No weird bridging issues or sloppy traces like some cheaper prototyping boards. Good size for small projects and nice having a pack of them on hand for future builds.

You can buy similar boards in many different sizes. For what I do I like this specific size in both single- and double-sided forms. Per-board the price is decent if you buy 5 at a time and gets even better if you buy 10. Whatever size you buy, make sure that the copper pads are tin-plated. I bought some boards with copper pads and some others that appeared gold-plated but weren't, and it was a pain getting the solder to stick even after polishing them with a dremel wire wheel. These are easy to snap to smaller sizes. Use a sharp metal scribe (not an Xacto knife - they tend to take off in their own direction) and a metal ruler to scribe a deep line wherever you want to snap the board. Then lay it on a sharp edge and snap along the line. (I prefer to use pliers to bend the board because that gives a cleaner snap and is probably safer, too.)

Decent quality. Takes solder well. Try to avoid rework because the pads lift very easily when desoldering!

They seem to be of good quality. I had to do some abusive soldering, unsoldering and resoldering and there is no sign of damage.

These boards worked great for my pedalboard power project. I was able to solder all components and wires to the board with no issues. Also very easy to cut to size with an exacto knife and drill standoff holes with a dremel, no problem. I will use them again in future projects.

The nickel pads sometimes lift from too much abuse, but the board itself isn't flimsy, and there are no fibreglass burs on the edges.