Question 1

so if you already own a tmaxx 2.5 and its old n beat. this would be a good cheap parts replacement bag?

Accepted Answer

TECH NOTES      This is the Pro .15 to TRX 2.5 engine conversion set from Traxxas.              It allows you to mount the newer 2.5 engine to an older T-Maxx.                                                                                        FEATURES: Tuned pipe, bellcrank, & throttle servo horn made of plastic                   Linkage wire made of steel                                                                                                                          INCLUDES: One Plastic Tune Pipe w/Wire Hanger (TRAG5152)                                 One Exhaust Header w/Screws & O-ring (TRAG5140)                                One Exhaust Coupler (TRAG5246)                                                 One Slide Carb Link Bellcrank (TRAC5167)                                       One Slide Carb Linkage Set (TRAC5168)                                          One Drill Bit for drilling Bellcrank Post mounting holes                       Two Tie-Straps for mounting Exhaust Coupler                                    One 90-degree pressure fitting                                                 One 3x10mm machine cap screw w/washer                                          One instruction sheet                                                          One drilling template sheet                                                                                                                         REQUIRES: 2.5 engine stock clutch system and stock engine mount                                                                                               SPECS:    Tune Pipe Length:           101.6mm    (4")                                    Header Pipe Outer Diameter:    13mm  (.51")                                    Drill Bit size:             3.175mm (.125")                                                                                                         COMMENTS: If EZ Start system is needed, use TRAP5271

Question 2

Where do I drill the holes for linkage

Accepted Answer

The kit includes a sheet of paper that has the drilling spots on it just line it up with the edges of your chassis center punch the spots of your holes and drill it

Question 3

Will this kit work to install a 3.3 also?

Accepted Answer

Yes, this also works for the 3.3 engine.

معلومات عنا

خدمات العملاء

دعم العملاء

الوصول الإقليمي

القانونية والسياسات

اجتماعي

احصل على التطبيق

Traxxas 4900 T-Maxx Pro .15 To TRX 2.5 Upgrade Kit

الوصف

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة