Q400 Ultra Wireless Crane Remote Hoist Winch Control Kit | Upgraded 4 Channel Button 12v 24v Hoist Overhead Bridge Crane Industrial Radio Dump Trailer Controller Transmitter Receiver

Works great! For roll off dumpster set ups 1goes to positive terminal 2 goes to negative terminal or good ground. 3 goes to positive terminal with 1. 6 goes to up pressure switch. 7 goes to down pressure switch. 8 goes to winch. 9 goes to winch. Took me about an hour to fully set it up. Super easy and convenient once it’s hooked up. Now I can do everything from the truck with zero issues.

Works exactly as expected. Very long range. Nice quality. Easy to setup. All I had to do was wire it in and it worked off the bat no messing around with syncing. Range is crazy far. I can use it from outside my shop. I have no complaints aside from the instructions if you’re wiring it to 12/24v DC they only list for AC. But basically for DC wire 1 is power. Wire 2 is ground. 3 is your common. And the rest are your outputs. I even used the start as an output. Great product.

Installed this on my BigTex Roll-Off setup and it works flawlessly. Needed to purchase 2-Five Function relays to reverse polarity on the Badlands Winch and I used 1 dual input diode for the Hoist Pump solenoid. Total cost through Amazon including all parts , less than $180. Highly recommended this remote.

The only thing I will recommend is to install a time delay .05amp inline fuse. The regular fuse kept blowing when I turned my battery disconnect switch on due to power surge. #1 wire power with .05 amp fuse, #2 Ground wire, #3 Power wire 10 amp inline fuse, #4 not used. Its for a light, #5 not used its for a bell or siren, #6,7,8,9 ore your up/down/in/out. You can wire each button how ever you like.

Used as a replacement for a wired four switch remote for a chair lift, this control kit is perfect to connect a 12v power to control the different directions for a lifting mechanism. Recommended for utility.

It worked great for two days , then nothing would work, I tested the incoming 12.5 volts , when I tested all four signal wires had zero volts , checked and rechecked all connections , the red and green lights on the controller would come on and could hear relays clicking inside of the base , but no output voltage

Well build. Good ergonomics. Easy setup and installation. Highly recommended.

They work great, I bought 5 for various projects

Beaucoup mieu que les kit "LODAR" a 300$ la manette seulement ...... Celle-ci possède un failsafe sont hyper réactive aucun délais et la porté j'ai testé 200metre sans probleme. C'est parfait!!!!! De plus j'ai pu ajouter le controle des deyx vitesse du PTO. Serieusement ont va en instaler sur tout nos remorqueuse!!!

Macht was es soll. Wirkt sehr robust. Installion für die Elektrofachkraft problemlos machbar

Works good! Some instructions would have helped but managed to get it working with some relays to make some actuators move in and out.

top kranfernbedienung hat an forstseilwinde sofort funktioniert

Item worked flawlessly for 6 weeks. Used on a tilt trailer, range exceeded expectations, could use it from over 100' away. Then all of the sudden stopped working. No blown fuses, no issues with the electrical wires, power was getting to the circuit board. LEDs on circuit board wouldn't light and couldn't pair the pendant. Called Amazon customer service for a resolution. Item was refunded and I have gone to purchase a different brand.