JETech Screen Protector for iPad Pro 12.9 (2015 and 2017 Model), Tempered Glass Film

So i was abit hesitant to buy any screen protector for my ipad pro mainly because i knew that the install of it would be a nightmare. However i noticed a hairline scratch on my screen the other day and decided i don't want to ruin the screen anymore. I decided to get a screen protector and chose to get a tempered glass one because i have matte screen protectors over all my gadgets ans although it is great because you get no fingerprints, not reflections. It honestly ruin the screen resolution. I applied screen protectors on large screen devices before (surface book and galaxy note pro 12.2) so i kinda had an idea what to expect. But i gotta say. Up until this screen protector, i hadn't had a perfect install. I can't say the installation was easy. I mostly used the same procedure to install the icarez screen protector but i made my own DIY icarez kit with just wide tape (the one used for electrical work) and aligned the screen first. Taped it on at one side. Created my own handles using tape (didn't use the tiny stickers they provide. I don't know if that would've worked) to lift the screen. lifted the screen. Cleaned the screen carefully with the cloth provided. I had to test my own handles i created before actually removing the back cover to install the screen just to make sure when i lift the screen it doesn't fall and it lands on the screen aligned. Then used the sticker to remove dust particles. It's not easy since dust particles keep falling.. But i tried to be a bit patient with it and be very quick when i actually start putting on the screen protector so no more dust particles fall on the screen. I ended up not having any dust particles under the screen (Thankfully) tried to remove all the bubbles but had three coin sized bubbles that were just stubborn. However since there wasn't any dust particles under those. I searched online and it seems that sometimes some "moisture bubbles" can be a bit tricky but they usually go after awhile. So i decided to not try and take the screen protector off and just leave it and wait. Then next morning. Viola. No bubbles.Cons:-Tricky to install but mainly because of the large screen size.-i would've preferred they provided more products for cleaning the screen other than the cloth. Wet wipes and dry wipes for example. (i was a bit worried that the bubbles i had at the end was because i didn't clean the screen by nothing other than the cloth they provided but since the bubbles disappeared. It's fine)- The ipad pro screen is such a fingerprint magnet. The screen protector limit that slightly. But i can't say it is fingerprint free screen protector. Nothing like an actual matte screen protector for sure.Pros- Price (not expensive in my opinion)-seems to be durable.- Screen still looks amazing after installing. Apple pencil still works fine

I don't normally bother writing reviews for my purchases but I'm so impressed by this screen protector that I thought I would this time.I've bought and applied many different screen protectors of different kinds for various devices over the years and found that this one has gone on the best. Absolutely no bubbles!! I was very nervous because of the size of the screen (12.9 inches) that I would have difficulty but it went on perfectly at the first try.It comes in a very sturdy box with a cloth for cleaning, a blue sticky sheet for removing dust (which was perhaps a bit smaller than I would have liked but I can't complain about the results) and a couple of sticky tabs to help you align it.The protector itself is an absolutely perfect fit from edge to edge (barely a quarter of a millimetre smaller than the original screen) and around the home button and with about 0.5 to 1mm clearance round the front camera.For this reason it is important to get it lined up right and to do this I ignored the instructions (which say to put the tabs in opposite corners and lower the whole thing down onto the screen in one go). Instead, after cleaning the screen, I lined up the protector, with the protective backing film still on, and stuck tape onto the front of the protector that wrapped round the long side of the iPad and round to the back of the iPad to make a kind of hinge at the top and bottom of the long edge (making sure the tape was pulled quite tight). I used the two sticky tabs supplied to stick on the opposite edge to use as handles. I lifted the protector out of the way and used the blue sticker to remove any dust on the iPad screen. Holding the protector by the tab handles I peeled off the protective backing (trying to keep the underside facing downwards as much as possible to avoid dust falling onto it) and used the tab handles to lower the protector into place while pulling to keep the sticky tape hinges tight to keep everything aligned. The result was perfect!Before I applied the protector the iPad screen tended to be a complete fingerprint magnet and a constant smeary mess. But the protector is absolutely brilliant. I've been using it for a few days now and haven't cleaned it once but I can hardly see any fingerprints. The clarity and sensitivity seem great too.I would thoroughly recommend this product.

I don’t often write reviews,except on the rare occasion when I am truly blown away by a product.Over the past 7 years,I have used many different screen protectors,some good,some ok and some just terrible.This was my first experience with a tempered glass one,having usually used a standard film type.Firstly,the packaging was very,very good,no expense spared.The instructions were brief but clear.I cleaned the screen with the cloth provided,and found very little to no dust settled.The placement was very easy as it doesn’t stick hard at first,so adjustments are really simple.The protector sat on the screen and I could see the air flowing out from underneath as the protector settled.There were NO air bubbles....a first for me!!!!!! Just a perfectly aligned and very classy looking protector..Honestly,I can’t recommend this product enough,particularly for those tired of battling with air bubbles and dust particles,and I would not hesitate to buy again.........although hopefully I won’t have to.