If i set the dial at 8 btdc so balancer lines up w/tab, and then move the dial to "0", the balancer will be at 8 on the tab, correct?

Thank you for your question. Yes, that is correct. 1. Rotate the engine to TDC on the Compression Stroke of the #1 cylinder. Both valves should be closed. 2. Install the Degree Wheel on the crankshaft and set it to zero. 3. Turn the crank backwards until the degree wheel reads 8 degrees BTDC. 4. Align the distributor rotor with the cap location for the #1 spark plug wire. 5. Line up the magnetic pickup with the reluctor. 6. Just slightly rotate the distributor backwards from the normal direction of rotation. The contact points should be barely misaligned. Install the distributor and tighten it down. 7. The Initial Timing is now set for 8 degrees BTDC.

Is the Innova 3568 timing light "self-powered"?

No, it is not. It requires a 12V source to connect it to. Typically, you're using the timing light in the engine bay, so you can connect the lead to the car's battery. If your car's battery is in the trunk/boot, most such cars will have a connector somewhere in the engine bay specifically for use with a timing light.

Which way does the arrow face on the clamp that gies to 1st plug wire?

I'm not 100% sure if the inductive pickup detachable lead is directional, but I would always clip the inductive pickup on the #1 plug wire, with the arrow pointing towards the spark plug. The direction of flow from the distributor or coil pack. It always worked for me, but like I said, I'm not sure if it's directional or not.

Manufacturer	Service Best International B.V.
Brand	Innova
Model	3568
Product Dimensions	36.83 x 25.4 x 8.89 cm; 226.8 g
Item model number	3568
Manufacturer part number	3568
OEM Part Number	3568
Item Weight	227 g

INNOVA 3568 Digital Timing Light

التفاصيل

الوصف

المواصفات

لديك سؤال؟ انظر ماذا طلب الآخرون

الأسئلة الشائعة