81107-2D020 KDLT002 DDLT002 HID Headlight Ballast Control Unit Module for Toyota Lexus Lincoln MOTOALL

Ballast works very good and no problem installing it.Easy fix. Easy to install it fits like a gloves. Good price as well no need to break the bank.

Bought this one for 50$ after taxes, was not a hight or below zero just a normal climate, installed at the electrician service. While installation the guy who installed said this is sh… ty one and not gon work after a week or max month, I didn’t believe what he said. After a week or a bit more it just stop working. My own recommendation, buy used original ballast!

Ballast arrived promptly and fist under the headlight as expected. Some other ballasts DON'T fit my car, despite wording saying they do. Dimensions for this ballast were accurate.After 3 weeks, ballast is still working properly - it fires right up just like the genuine Lexus ballast still in the other headlight. While these are a pain to replace, andone reasonably handy can get YouTube instuctions and DIY for just the cost of the ballast. Local shops wanted $1,200 to do it using only genuine Lexus parts, so you can save well over $1,000

If you are replacing the ballast on a (S1 up to 2008) RX8 this will work. (Don't think this applies to S2 as the headlights are different, after 08) The "Correct" Way to do it Is to remove bumper and then remove the headlight. With the headlight removed you spend 20+min with a heat gun to heat the headlight and separate the "glass" part from the housing as it is imposable to get the wire out without doing that. My way is the beginning portion but instead you cut the wire to remove the ballast(use scissors with plastic handles as ballast may still have a charge), then you make a slot or drill a hole in the housing for the wire and another going in to the place where the bulb goes, this way you do not have to unglue then reglue the "glass" part. There may be a proper way to do it that does not involve drilling in to the housing or ungluing it to fix it but that is one I do not know of. PS the connector that comes with it does not work for RX8 but you just have to unclip it and plug it in to the old one that you have to unclip to remove anyway (This is the correct ballast/size its just the design of the S1 headlights) (5 stars now as it works good, will update if it breaks)

The connecter is wrong for the is300. But I just reused my old one. Plugged right in