20 PCS 2-Pin 8mm Solderless LED Strip Connectors, Reliable and Easy-to-Install, Solidly Connected LED Light Connectors

These work great and save a lot of trouble over soldering, especially in tight spaces where it might not be easy to work with a soldering iron. One side is fully divided to screw in your hot and ground wires, and the other side is divided with a little gap at the bottom to slide the LED strip into. Screw down the screws onto the wires and any 8mm LED strip cut on the cut line and you'll be good to go. I've been using them for about 2 weeks and have't had any shaky connections or other unreliability. Very satisfied with this item.

These worked perfectly for when I had to cut LED light strip. Good deal. Just make sure you cut the strips in the right place.....you can't just cut them anywhere. Other than that you are good to go.....even comes with a screw driver for those tiny philips heads in them. Fit perfectly when done right

These 2-Pin 8mm Solderless LED Strip Connectors are a great solution for quickly connecting LED light strips without the hassle of soldering. I used them for a recent DIY lighting project, and overall, they worked really well.The installation was straightforward, even for someone without much experience. The connectors hold the strips securely, and the connections are solid—no flickering or loose ends. It’s a huge time-saver compared to soldering, and it makes it easy to adjust or reconfigure your setup if needed.My only complaint is that the plastic housing feels a bit fragile, so you need to handle them carefully to avoid breaking the clips. Also, aligning the LED strip correctly can be a little tricky at first, but once you get the hang of it, it’s smooth sailing.Overall, these connectors are a reliable and convenient option for working with LED strips. They’re not perfect, but they do the job well for the price. I’d definitely recommend them for hobbyists or anyone looking for a quick and easy connection solution!

Easy to use, good product.

Very good connectors for LED light strips. Small connector that is easy to hide with good contact points and super tight connections! A must-have for connecting LED light strips. Will buy again when needed.

They make it so much easier working on my projects. No need for soldering

They will work if you are unable to solder. I bought these thinking it would save me time over soldering each connection. The problem I found with these connectors is that when you tighten up the screws it just bends the plastic. This makes it unable to tighten enough so that the led strips or wires can pull out of the connector. I ended up soldering my connections instead.

WOW, WHERE WERE THESE WHEN I FIRST STARTED INSTALLING LONG LED STRIP LIGHTS!!!? I HAD BEEN USING THE PINCH DOWN TYPE CONNECTORS FOR ALL OF MY PREVIOUS LIGHT STRIP INSTALLS IN THE PAST. I WAS LEFT WITH A MESS OF LOOSE CONNECTION POINTS THAT WERE HARD TO FIX . i CAME BACK TO THE DRAWING BOARD TO SEE IF i COULD FIND A BETTER PRODUCT THAT COULD SOLVE THE 2 MAJOR PROBLEM i HAD WHILE INSTALLING LIGHT RUNS, THOSE WERE BAD CONNECTIONS AND DIFFICULTY REPAIRING THOSE POINTS. WELL, I LEARNED MY LESSON...WITH THESE, IT MAY TAKE A FEW SECONDS MORE TO USE THE TINY SCREW DRIVER TO MAKE THE CONNECTIONS BUT AFTER A VERY LONG RUN WITH AT LEAST A DOZZEN BREAKS, I HAD NO CORRECTION DELAYS BECAUSE EVERY CONNECTION POINT WAS CLEAN AND SECURE. IN FACT, I HAD A SECTION WHERE THE TAPE ALONG THE STRIP HAD LOST ITS HOLD AND ALL THE WEIGHT OF THAT 25 FOOT RUN HAD FALLEN ONTO THAT LAST SPLICE, AND THERE IT WAS...HANGING FROM THAT LITTLE CONNECTOR, HELD SO SECURE THAT I BET I WOULD TEAR THE STRIP ITSELF BEFORE IT COMMING LOOSE FROM THESE BAD BOYS!