Marine

Bon produits pour le bois

I am returning to leave this review having 3 years of experience with this product. I purchased Seal-Once Marine Penetrating Wood Sealer (clear) in June 2023, 3 years ago, and applied it to a large gazebo (from Costco) on my deck. Seal-Once has done a phenomenal job of protecting the wood, and the gazebo still looks almost new. My experience with prior brands of sealer/waterproofing caused me to do a lot of research while selecting which protection to use on my new gazebo. I live in sunny California so sun damage was my primary concern, but we average 54” of rain annually so I was also looking for water protection too. I have been pleasantly surprised that this product has really surpassed my expectations. I am a very satisfied customer and will continue to use Seal-Once Marine Penetrating Wood Sealer. (The attached photo was taken right after the gazebo was first installed.)

I was hesitant about ordering this based on other reviews. Product came well packaged. It mixed no problem. I am refinishing my dock. It has never been coated and is made of cedar. I stripped the gray with 50 grit belt sander. Then these photos before and after with 2nd coat applied. It was much easier to apply with an exterior stain pad then a brush and saved alot of time using that method. Keep a brush handy though to smooth out. Not sure why the colour tints are not available here but would have loved to get the cedar color.

Put one coat on some cedar fence last year. Noticed the other day how good it still looks. Went and coated it again and the product beaded up just like it was applied yesterday. Excellent outdoor sealer. This penetrates and makes water bead up but does not leave much of a surface film. Its super easy to apply and totally forgiving.

Having just applied the product to a full sun and rain deck application, I found the product easy to apply and clean up. Not sure about longevity at this point, but water beads up. Product leaves a satin finish. One point: I applied the first coat and waited 20 minutes to apply the second (I individually coated each deck board on all sides and ends). The second coat is still sticky three days later. I began to watch the absorption rate on the first coat and applied the second coat much sooner, allowing the coats to blend and the final boards had only a very light tack to them after 24 hours. The temperature maximum was 85 degrees during the applications.