BIGTREETECH TMC2209 V1.3 UART Stepper Motor Driver Module VS TMC2100 TMC2130 Taco V1.1 / Taco Pro / SKR V1.4 Turbo / SKR 3 / Manta M8P/M4P/M5P 3D Printer Controller Board 1

Bamm, just like that brought my Artillery S2 back to printing. I have to say after trying several other replacements, this one is dead silent like the original driver. Thank you!Edit:Awwww for some reason the step motor on my printer now runs backward. Boo. I think it's still a five star for someone else. I don't want to learn how to edit my firmware for this.

I ordered 5 of these total to upgrade the stock drivers in my Anycubic I3 Mega (previously upgraded with the Mega S upgrade kit). Now the machine is so quiet that when I started it printing, I thought the extruder wasnt working at all. The ONLY noise coming from it now is the fans, and I have upgrades in the works for those too, as well as some MOSFETS for safer power to the hotbed and heater.

Reliability and quality. Great product!

This stepper driver was to replace one on a functioning 3D printer. The existing one was a 8825 for the bed axis. I was getting overshoot at high speeds, and thought a larger motor with a driver that could handle more current would help. So far, I replaced the driver, but not the motor yet. I had to change a jumper setting on the board, so the steps would match my existing setup, as the 8825 used the jumpers in a different config. It works well, and made that axis of the printer much quieter. However, it actually doesn't hold as well as the 8825 did. I tried adjusting the current, but would still lose steps at high speeds, where the 8825 could still hold. I had to adjust my jerk speed down some for this driver, and it is smooth and quiet, but was hoping for more on the holding power. Maybe with a new motor, it will do better. If you're looking for a cheap upgrade to really cut down the noise, then this is for you. I wasn't concerned about noise, just looking for something that could handle more current.

Ender 3 Pro + SKR v1.4Turbo + TCM2209 Stepper drivers = 1 Awesome Printer!compared to the basic Ender 3 Pro steppers, these are 1 hell of an upgrade!You go from EeeEEEeEEeeeE sounding movements to Wooooosh Wooooooosh hahahhahahhaRead the instructions carefully, you may need to cut a pin off the driver board. Easy tho.The included heat syncs really do a great job as well.I've run a couple prints, lasting a few hours, without having the lid on my components case, so no fan... Never had the printer shutoff from overheating.As long as you update you firmware correction and using a compatible board, these stepper drivers are great!