4 pcs DC 5V 1 Channel Relay Module Board Shield High/Low Level Trigger with Optocoupler

I installed two of these on my tractor for controlling a larger high current solenoid switch. I had to add a DC-Buck voltage regulator upstream of it, due to burning out the first one, since somewhat wild 12-14.5V was just too much for it (it worked fine for about a day, then died.) The second one has been performing flawlessly for a couple months now. 😀

Excellent product, using it on my HO railroad to control RR crossings, it took a little studying to figure out the wiring to actuate the relay, once I figured it out they work perfectly. Would buy again for sure.

My use is to power up a USB power supply using a USB port on computer as trigger. I have some lighting that I want to always come on when the computer is powered on or comes out of standby. The PCI-E USB card I'm using powers down in standby so I'm running a cable from that to trigger this relay which will close the AC circuit on a USB power supply. I could've potentially powered them from the USB card on the computer but I'd rather subcontract this power demand to a lesser device. Using my inline USB voltage and current meter, (so-so quality, readings always seem appropriate and correlate with the load put on it but I haven't checked it against a VOM), standby current was too low to read and with relay engaged it showed 80mA. Resolution on this USB meter is only 2 decimal places so something under 10mA for unclamped state. I could've just used a 5V relay for this task but I haven't seen any with 1/4" spade terminals and it's convenient having a board to solder the 120V wires to. For the price I went ahead and got a 5 pack for future projects. I was able to use only USB power by connecting red(+ from USB cable) to DC+ and IN terminals, and black (- from USB cable) to DC- terminal. This initial use is just for "bling" but I can imagine many applications where having switch control conditional to a computer being on or off would be handy.

I'm using this with two Raspberry Pi boards (one a 3B+, the other a 2B) connecting both the 5V to power the solenoid board and using the PI 3.3V GPIO to turn on/off. One of the 4 units was defective out of the box but the others are working. For the money, they are a good choice. Note that there is a severe limit on the current available for GPIO switching from the Pi, so the single-channel model would be the only viable choice. I am able to use this to power a 3D printer on/off by switching the AC power using the OctoPrint PSU control add-in, which simply raises a configurable GPIO pin.

I’m using this as a relay for a power supply to a Raspberry Pi used as a media center. The tv usb doesn’t supply enough power for the device, but now it turns on and off with the tv but powered through an external 5V supply capable of the required current. Ideal. I only wish it had usb interfaces instead of bare wires...

Using these with the Octorelay plugin for Ocroprint to turn my printer and lights on and off. Working great!

I use these on the outputs of Raspberry Pi for automation tasks. I like that they have LEDs to show power supplied, and also if the relay is picked. They're compact, come with screw down terminal blocks for both input and output, and have mounting holes. Can't think of a way to improve them.

Well built relays with screw attachments on both ends and your input can work on either high or low. Great for isolating AC signals.

Ils font partie d'un système de domotique