Scandvik Low Profile Drain Stopper - 1" Outlet

Awesome drain! Used to build a cabinet for a camper van. Very pleased! Can recommend product isn't cheap

Had to dremel the drain hole out about 1/8" to get the top piece to sit flush. I also had to raise the shower pan about .5" to allow space for the drain and the attached hose and clamp. I'm still giving 5 stars because it wasn't meant to be application specific but worked beautifully with minor changes to my setup.First picture shows flush mount top side. Second shows the inner workings of my shower pan frame.I used extra sections of 1x3 stacked in pairs for true 1.5" plus 1/8" sheet board so my shower pan wouldn't flext when I walk inside. I used .75 x 5.5" mdf lengths to frame out the base of the shower pan. The drain leaves just enough room to run sideways into the section where it dumps through the van floor into the grey water tank. Hope this helps someone out there.

I've put together a hillbilly hot tub in my greenhouse, but don't use it often enough to warrant chemicals and whatnot so I just fill and drain it as needed (propane hit water heater). Was struggling with the drain that came on the tank as it always left an inch of water at the bottom. This took minutes to install and bonus points, it's the perfect size to tap a garden hose onto it. Works absolutely stellar.

Works well

I purchased this drain for 36"x24" RecPro shower tray I'm installing in my van. What a perfect fit! Product also seems good quality.

This was a godsend, and it saved me from jerry-rigging my campervan sink to a discharge hose. Low profile and works well. I had to file the hole on my sink a little to make it fit, but that was negligible work (10 minutes with a metal file did it).

Be aware of the rounded inside corner, if you have a 2 inch opening this will not fit, for a stainless steel sink you will need a 2-3/8 opening for it to seat right unless your sink has a matching downward rounded edge. Mine did not. Hope this helps! Cheers

Agree on the easy install. Looks good. I drilled a separate hole to hold the chain for the stopper. Good quality. I wish the whole thing were stainless and not plastic but meh, it's the way of things these days and frankly... plastic doesn't rust.The trim ring is stainless and chrome.