Genesis GAMT613 Universal Quick-Fit 3" Tapered Sealant Cutting Blade

Blade fit my milwaukee oscillating tool just fine, worked perfectly for removing the rear window from my parts car. Urethane is hard to cut through, this did struggle at times and threw off some smoke, but made a hard job a lot easier.I bought two blades and ended up bending one on an angle for a couple hard to get to places, it worked for most of the job but did break at the bend. It wasn't designed for it but I'm surprised it held up as well as it did.

This blade works great for removing the glue in windshields in cars. It made really quick and easy work of the removal

Cut through the existing caulk between my pool deck and coping very nicely. Wore quickly, as it was cutting against a masonry edge, but one was enough to finish the job. Fit my Porter-Cable multi tool perfectly. Dewalt has the same bit for fifty cents more, which I did not discover until after I ordered. Not sure which one is thicker/sharper/wears better, but this served its one job purpose.

I DO NOT use this for what it's intended. I bought this over a year ago for a "just in case" situation. Well I bought a cordless box cutter and it wasn't cutting through the thick cardboard. I remembered I had bought this and gave it a try on my DeWalt multi tool. MAN! This thing went through that super thick cardboard like a light saber. Just bought another as a backup. If you cut a ton of cardboard this is highly recommended.

Attempted to use this in oscillating tool to cut a rear window out, took forever to do a small area. Switched to a cutting blade with teeth did about th e same.I ended up welding this onto a rod and use it as a push tool to slice urethane in corners if needed, I also sharpened the edges.

I used this to remove the flexible seal around my pool. Was very easy and I did the whole pool with one blade.

I have found this blade to be very effective with very old adhesives and caulking, some times a razer knife "Just cant cut it". this blade makes short work of a problem mess. Multi tool on low and blade cuts the caulk away.Tough blade helps a lot in those tight placesMONEY WELL SPENT!

Was using it to cut caulking and worked great on rigid job max. About 2ft into cutting and the bottom right side of the blade broke off in the straight cut position…not really recommending unless I get replacement and will hold up. Money down the drain.