Direct Store Parts Kit DG101 Replacement for Charbroil Gas Grill Burners,Heat Plates and Crossover Tubes, for grill mode 461261508 461262006 463248108 463268008

Kit included everything needed for about the price of one flame shield in home improvement stores. Biggest problem was removing screws from original parts. Included screws are not useable but that is a minor inconvenience.

Despite specifically listing my exact grill model as being compatible, these are NOT. After spending almost two hours in the blazing heat tearing everything down so I could replace the burners, I discovered they are made completely backward and would have to be installed facing down in order for the electronic ignitor to attach! On top of that, the screws provided are too large and cannot secure the carry-over tubes to the burners.Turns out the problem is a CharBroil one, NOT a Direct Store Parts one. CB, too, sells supposed replacement burners with the same defect - told me to just move the electrode to the left side - something I can't do since the cutout for it exists only on the right! They've opened an 'investigation...'CharBroil has now confirmed that these burners are safe to install and use on my grill, despite the changes in design that threw us (CharBroil and me!) off.

The parts fit my grill and work as intended. Saved money replacing the heating tubes as the main grill was in good shape.

All parts dropped in and fit perfectly for an easy installation, I used them all last year and they are holding up to the heat and use better than original. A good value for the money.

Perfect fit burners, cross-over tubes and heat plates for my Char Broil Grill. Good quality. Does not come with hold down replacement screws.

I watched a Youtube video of my exact model grill being repaired and ordered these as a result. The parts I received did not fit. The burner tubes were each about three inches too long and the crossover bars about one inch too short. After about on hour with an angle grinder, hammer, and pliers I got everything installed. BEFORE PURCHASING TAKE APART ONE OF YOUR BURNERS AND MEASURE THEM! Then you can compare to the parts listed here.

The hole on the tube is a bit small. It is difficult to screw the connecting plate togather, I have to drill the tube hole a bit larger to match the screw. Else it is very easy to install.

All the info I had indicated the parts would be compatible BUT: my grill has a natural gas conversion kit so the intalled burner had a yellow flame. When comparing with the old burner, the holes in the side were larger on the new burner, and the air intake at the valve end had a smaller cross section. There should be a disclaimer in the product description that the parts are for the propane version, not the natural gas version. A few parts are interchangeable but overall, the kit is pretty much useless unless I convert the grill back to propane.