Matek Systems HUBOSD8-SE PDB OSD Power Distribution Board Dual BEC 3S - 6S Supported 184A Current Sensor For FPV RC Drone and Crazepony Strap

Good. Osd works fine. Great for if you need a pdb and want to get an osd but are tight for money.

Works great rite out of the box. NO UPDATE NEEDED!EZ update if you have a TTL converter sold on Amazon if you do not have one.You can you serial pass through on you flight controller otherwise, This might sound intimidating if you are new to this but at the Matek site for this board it gives EZ step by step instructions. This is how i did it and it was butter smooth. This gives Min. Max readings for volt and AMP and constant currant updates so great for Race or Acro very minimalist doesn't crowd your screen.For the price simplicity and function This is a winner.

Osd worked at first then failed first flight out of the box....pdb part was ok though

If you are looking for a PDB that also does OSD, look no further. This board works great, has good pin layout and is easy to solder up. The only con I have found is the lack of proper RSSI support. If you, like me, want RSSI displayed on the OSD do not buy this PDB. You will be dissapointed. Rather buy a non-osd PDB and use a seperate dedicated OSD (like Piggy v2) that supports something like MWOSD on which development is ongoing. STOSD development seems to have stagnated.

Good PDB... The amount of sol-der sah-der... the amount of tin they want you to use on the power cables to the pdb is a little out of hand but other than that it works as it should. OSD works. Text is a bit big but not distracting. I don't use the OSD anymore as I've switched to only purchasing FCs that support betaflight OSD but the pdb is still going strong!

very good design however the 12V regulator died on second day after 5-6 flights on 6S, which is suppose to handle 6S and I did out on the capacitor as per instructions....dissapointed

I bought two and bought this for using osd voltage function . My Fc has osd function but not working anymore since last week. i think vin and vout pad is dead.This pdb is very useful who doesn’t have osd board but want to check the battery voltage during flight instead of usning loud beeper.

plug and play, so easy to use. favorite OSD if you got room in your stack for it