Viborg Audio 4XPure Copper Speaker Cable Banana Plug Gold Plated Banana Connector Plug

good

I bought 2 x 4 of these banana plugs and 3 screws were missing and 1 screw was upside down so I couldn’t get it out. With quality like that, I doubt the materials are any good.

these pure copper banana plugs. they say it takes a while to brake in or here a difference. i hooked up the speaker cables., turned on the stereo. And right away I could hear a big difference in the cables. It gets better every time I turn it on.

Makes me sick that Amazon doesn't seem to know if they'll ever get these again. They're an outrageous bargain and have the best design I've found. I've had some much more expensive units from Furutech and DH Labs, but I easily prefer these. Solid copper in your choice of finishes and a fairly unique method of staying put once installed. Most bananas, even the locking ones, have very small actual contact points. These use a tensioned pin to push the entire opposite side of the banana against the inside of the female plug. Ingenious.

I bough two sets of these to replace the other mediocre Gold connector ends of speaker wire for item: "GearIT 10AWG Speaker Cable Wire with Gold-Plated Banana Tip Plugs"I was able to strip off the 10AWG leads a bit better from the Gear it cables to accommodate the new Viborg tips with better results. Its a good thing I removed the original Gearit Gold connectors and checked the wire because you will find out the factory preset connections, upon disassembly, may have strands that have been damaged, crumpled or misaligned and not completing the mechanical connection altogether. I was able to identify and correct any strand-length deficiencies just before putting the new Viborg plug-ends on, that now improved by the newer two screw design to fasten this beast of a wire gauge and more securely locked in place.--The only thing missing from my choice of this brand is buying another version that allows you to have the tip curved at a right angle so that the cable coming off the speaker terminals would not end up sticking strait out with no flex. I had not accounted for the length of heat- shrink, cable, and connectors all mounter together - as constructed. Without an angled connector the cable would not bend up closer on the speaker terminal where it needed to be angled, left or right. Now the speaker has to sit further away from the wall.