ForgeFix Masonry Anchors - Eye Bolts | M8 | Zinc Yellow Passivated | Bag 10

I found nothing to dislike about this product. You have to make sure you install it correctly by allowing spare space in behind to allow for fitting properly. About half an inch or about 13mm extra is needed but no instructions are included. The product size listed is not the fitting size. I purchased an M8 anchor which needed a 14 mm drill bit to fit. If you are fitting an M8 anchor it is wise to use a 13mm drill bit if possible first and see if it can fit as often there is some crumbling depending on the surface being fitted to. Clean the dust out of the hole with a small paint brush or whatever else. You want a tight fit to make it strong. I put some indoors into plaster with thermal blocks behind. 13mm was only needed for that due to some crumbling. Outside on brick I used 13mm first but still too tight to insert so I had to use a 14mm bit. You have to tap in gently - do not force if it will not go in with light taps with a hammer as you may damage the spring fitted to the anchor. One went in perfectly but the other was not such a tight fit but ok. Results of fitting seem somewhat variable. They tighten nicely to a strong anchor. There is no need to overtighten. I use these as safety lanyard anchor points for a safety harness such as being safe sitting on an upstairs window sill and leaning out somewhat to clean soffits etc.

I bought these because I have to clear the Ivy etc from the barge boards around a large three storey country house. I normally have to do this off a three stage extension ladder except on the odd occasion when my employer feels flush enough to hire a cherry picker. Working at the back of the house means placing the ladder on a stone terrace(slippery when wet) I've been using a length of fence railing with 6 inch nails hammered into the paving crack as a ladder stop. not good. solution, 12 of these inserted at equal distance low down in the wall means I can tie my ladder off with no fear of slipping( yes I know it breaks health and safety at work rules but it's my job) They provide a very secure anchorage and give me peace of mind and less shaky legs when I'm twenty feet up

great item 5 stars

great for fixing my sun sail to the wall

These bolts were perfectly ok but ended up using M6 bolts which used a smaller masonry drill

Follow the instructions and make sure you drill the hole the right size. Remove any debris. So strong and can hold heavy weights.

Easy to fit would recommend

Great price. Top quality