Eyelet Terminal to Female Cigarette Lighter Socket

Works fine. Quality exits with build. Could not DIY for this price.

Very impressed with the quality of these cables. Assembled very well and durable. Installed these on my Nissan 370Z battery terminals to have a good direct power source which will power everything i will use it for no problem with 12 gauge wires. Battery is in a compartment under hood, so just pop hood, open access door, easy access to power. The female cigarette lighter socket has a cap to protect it when not in use, had inline fuse that seals up very well to protect it too, also came with a velcro strap to hold it in place when not in use and extra fuses. Very happy with these and how it works for my intended purpose. Highly recommend these

Worked flawlessly heavy construction

might be a little light but seems to work ok.

I bought two of these. Hooked them up to a 12v battery in my van, one runs my 3cf DC fridge with 60/65w draw. Both the outlet and my fridge have their own fuses. The other outlet runs my 2- dc roof vents with 20w draw each. The lugs on this plug make installation a snap on a 12v battery. Nice thick gauge wire can handle the loads. Nice quality. Very pleased.

This product is very well made and of above average material selection. My only concern was getting the fuse holder thru the firewall of my auto without cutting it, routing it thru the firewall and then reattaching it. Fortunately I found a firewall opening that was just large enough for the fuse holder to pass through. . . I did however have to cut the top of the fuse holder off to accomplish this task. It was easily reattached once the job was completed. I used one of the Velcro attachments included for wrapping the wire to accomplish this. This purpose of this product is to allow the use of a 12 volt 200 watt inside auto heater defroster so I can defrost the windshield on my 1999 Jeep Grand Cherokee whose heater core has crapped out and left my drivers side carpet soaked with anti-freeze. I resolved that issue by bypassing the heater core but that essentially then left me without a means to defrost the windshield of my jeep. I opted on the side of overkill by using this product application rather than use the internal cigarette lighter outlet in the jeep. That fuse is rated at 10-15 amps range whereas the direct inline fuse on the product I purchased has a 40 amp fuse. I tested the portable heater/defroster for 30 minutes yesterday with the engine running continuously and these 12awg cables directly attached to the battery terminals remained cool to the touch after the trial. The smaller cable (16 or 18 awg) from the heater to its cigarette lighter male plug did get warm but not hot to the touch. My plan is to replace the wiring to the heater with 12awg cable in the future just to have peace of mind. All in all, this product did exactly what I was hoping for. If you should need to do as I did, buy this because of the heavier gage wire. You will not be disappointed.

Perfect for a high draw device such as an inverter. Very high quality, and high performance. A truly great value product. Works great with a 300 watt inverter. Adequate cord length for my needs. This is my second purchase of this item, so I’m obviously a happy camper.

Very well built & robust / heavy duty construction My application is for DC to AC inverter on my jeep. This is great for inverters in the 300 to 600 Watt output range the output socket has a waterproof cap that is high quality rubber and fits very snug. Wire terminations are high quality and unlikely to fail for years of service life. so you can install on your car or truck battery and leave inplace without concern of shorting out. has inline 30 Amp fuse

Very well built product. I am always hesitant to buy stuff like this because I hate cheap crap. This however is very solid and well built. They use 10guage wire with good terminal ends and shrink tube is thick rubber over the terminal ends. I like that it have a fuse built into it, although for my application doesn’t require it. Again, it’s a very well made fuse holder that looks like it can take off-road abuse. As an off-road guy that finds a way to kill pretty much everything, I’d say this is going to last a long time.

Nice unit, heavy guage power leads with replaceable fuse, the 12v receptacle internal contact area is heavy duty and very good quality.

I have not installed yet but does not look of cheap quality.. I'm sure it will be fine and will update after installation.

Real heavy-duty socket. Works fantastic. No mounting brackets on it and not really configured to hard-mount (the bulge at the base is wider than the opening) so, great if you don't plan on hard-mounting it to a surface.

I needed a cigarette socket capable of handling high amperages to charge my Yeti power source. This worked beautifully. I used it in my camper and it definitely can handle high current. These are hard to find and this one works great. I'm going to get another for my van.