TruscoGT-470-B 3-Tier Tool Box, 18.6 x 8.7 x 13.4 inches (472 x 220 x 343 cm), Blue

Really like this tool box the only thing I probably might change is the bottom level dividers because when attempting to put them in, it scratches the paint. Really don't like that, but then again it is a tool box. I love the fact that the whole thing is made in Japan, even the wheels that come with the tool box is made in Japan and it's really quality. It rolls so effortlessly, it doesn't make any sounds at all when it's rolling or when you roll it. Unlike some tool boxes where the wheels are made of plastic these wheels are made of some kind of rubber and plastic. Very durable. it's a bit difficult to put the wheels in but if you have a chisel preferably a cement chisel you can pry the underside of the tool box so you can set the wheels in place. A chisel and ball pin hammer did the trick. A few taps here and there and the wheels are set. The tool box can also close both ways either left or right it doesn't matter. The dividers are big enough to fit your hand in and the top dividers (round) are adjustable, the bottom (square) are not so make sure when you do put them in it's really where it should be, I just left them out for convenience sake. The tool box is made of pressed steel so it'll last quite a while and if it gets dinged just hammer it out and spray paint. It is quite heavy out of the box but with the wheels it's easier to push around, and it's lockable no latches to break-off. If you have back problems maybe this tool box is not for you, but if you want a tool box that's quality and will last then this is it. If for some reason water gets in it'll drain out of the sides. I slammed closed the lids several times to see if it was really quality and surprisingly it was! I might have dinged it but overall it still closed either way left or right with no problems. Mine came dinged on the corner but I didn't mind because it gave it some character.

Very nice box. The wheels are a nice feature but, wish they could lock. On a slopeed driveway or parking lot, it rolls. I like that you can open one side. It opens and closed smoothly and squarely. However, if you have a lot of heavier tools in top trays and open one side, it will fall over. This is a very good qiality box. I purchased because it is made in Japan not China. This box is pricey, cost more than my tools in it but, I can take it out to do auto or motorcycle repairs and all my tools are now in one spot. Wish I had two of these actually so I could store my specialized electronics tools for tube amp repair. It is a bit heavy when loaded with trasportation repair related tools but, wheels help when crawling around doing repairs. I recommend this tool box.

I work as forklift mechanic. This means that I have to carry my tools around large warehouses. The only con about this box it is heavier than a fabric tool tote. You can load this box with more tools than you can feasibly carry.The good: the craftsmanship of the box is excellent. I would put it on par with snap-on or Kennedy. The cantilever action is smooth. The dividers work well.I have used this box everyday for around a month and a half and I think it will last. I am able to fit a full set of metric and standard wrenches, hex keys, torx set, 1/4-1/2 socket sets, punches, hammers, pry bar, screwdrivers, extensions etc. Around 40 pounds of tools. I could carry more but then it would verge on being too heavy. I do recommend this box.

I am not sponsored. My toolbox just arrived and I am thrilled.Absolutely amazing toolbox. I needed something to hold a lot of different tools in one place as I move a lot. The cantilevered sections are large and spacious. The ends are big enough to hold altoids tins with the extra dividers removed. It doesn't feel unstable even when fully loaded. The provided wheels will make it very easy to work out of. 10/10 totally worth $200. I want to be able to justify getting a second one someday.I should also note, the wheels need to be hammered into the slots on the bottom to be attached.

This is an amazing tool box. I was looking at one of the Beta Tools boxes and I stumbled on this Trusco. I am glad that I did. It is well made, heavy, strong and roomy. Mine can with casters and I can see why some would want this on wheels. Loaded with tools this box easily weights over 100lbs. The "forms" in the metal act to strengthen the sheet metal. I never get the impression that this box is being flexed or stressed from use or abuse. I have (mis) used it as a stepping stool and let it slide around in the back of a pickup bed. I would buy this brand again in a heartbeat.

Excellent function of the hinges, beautiful paint job. Attention to detail is excellent. Made in Japan. Could use three of these, worth every penny to organize tools.

Kinda big and awkward to carry. Not very attractive looking like it is in the photos.

product came damaged

大型でキャスターを付けられ、使いやすい相棒です。ただ重さはかなりありますし、お値段も高いなぁと。あとキャスターは一度取り付けると外すことはできません。キャスターを圧入するときは、そのままだと入れにくいので、圧入箇所の戻り防止の出っ張りを少し叩いておくと入れやすくなります。

自動車整備用に持ち運びが出来る工具箱を探してて、こちらの製品を見つけました。流石、日本製だけありシッカリとした作りで頑丈です。仕切り板も用途に合わせて取り外し自由。使い込んでボロボロになれば、それはそれで味が出てくるもんです。この三段式にした理由は、開けると何処に何があるのか一目瞭然。ただ、工具をギッシリ入れるとかなりの重量になります。キャスターが付属されてますので、お好みで取り付ければ移動させるとき楽でしょう。私的には、色、大きさ、完璧。このトラスコの工具箱はビューでした。

しっかりした作りで使いやすい。ただ、工具を入れすぎると重くて持てない。

職場で使っていていつか自宅にも欲しいと思っており今回注文しました。最高に満足してます。箱に書いてある通り しっかりした製品です。メイドインジャパン結局お得です。

頑丈なためか重く感じる。中段の仕切りが入れにくい。使い勝手は良いです。