EEMB40PACK Lithium Polymer Battery 3.7V 150mAh 401730 Lipo Rechargeable Battery Pack with Wire Molex Connector for Speaker and Wireless Device- Confirm Device & Connector Polarity Before Purchase

Lowest price battery replacement for my device. fast shipping. good fit.

Previously bought an EEMB for my MecArmy SGN3 flashlight 7mos ago and it still gives full run times...12+ hrs on low. The original and a cheapy, about $5, didn't last 5mos. This one went into a VanTrue N1 Pro to replace the original. These definitely seem to be a quality battery.

The battery failed in my 5-year-old Old Shark dash cam. After prying it apart (you need to remove a couple of screws too, one hidden under an inspection label) I saw that the old lithium polymer battery was puffy. Bad, bad, bad. This new battery arrived in a day. Perfect size. I was planning on cutting off the connector because the battery is soldered to the circuit board. Instead, I carefully cut the plastic tab holding each connector pin inside the connector housing and extracted the pin. I soldered these pins directly to the circuit board. They stiffen the wires so they won't accidentally short out.

Wouldn’t recommend purchased and when it arrived it was the size for a Barbie doll not what I needed at all

Used this battery to replace a dead battery in an old bluetooth adapter. It was the same size as the original so it fit well. I didn’t use the connector since the wires in my old bluetooth adapter were soldered to the circuit card. Now my adapter works like new!

Tablet

Was worried this wouldn’t work for the remote control because I couldn’t match up numbers. The batteries we know worked were all out of stock but these worked perfectly.

Just what I needed to repair the rechargeable battery in my air mouse remote control.

My upright go battery gave up the ghost and suffered from leaking/spicy pillow. Took it apart and replaced it with this, it was a little tricky as the device was so small. Attached to the old battery wires that were connected to the pcb, I didn’t trust my soldering skills on something so small. Got it back together, which was a slight bodge on my part, as some plastic mounts had bust, but what can you do. All up and running and working well.Save me buying another and more e waste!

Seemed good at first but after about 10 cycles it wouldn't take a charge

Works as it should, i didn't need the socket and could've done with longer tails but still saved the unit by changing the battery.

This battery had a very poor capacity, it only ran my model helicopter for 2 minutes before going flat, very disappointing. I definitely wouldn't buy this product again.

It worked great until I overcharged it and it stopped working. It was my fault. It worked great up until then though.