Rollerbones Bearings 8mm 16 Pack

Great product. Satisfied!

Best bearings for the price point! Will outlast those lesser brands and comparable to some of the more expensive brands on the market! Excellent for roller skates and rated for speed!

The bearings were packaged well, I inspected each one for good smooth spin, all were perfect.Installed into my Rollerblade wheels, got out for a 12 mile skate, they felt great. Quiet, smooth, felt like new bearings should.I skate for fitness in-between gym days, most comments about these bearings on inline skate discussions are positive, the next quality level up from Rollerbones, the Reds, are about $40.They make bearing sets that go up to $200.For what these cost, if I get my "season" from this set, I'm happy.

The media could not be loaded. I’m new to skating and when i intentionally got these skates i loosen the bearings a little bit (bearings ABEC-5). However, when i went indoor skating i was constantly loosing momentum and having to push harder to keep it up. I bought these and as you can see in the video they roll longer and faster than my old bearings

I buy these regularly as they were recommended by a friend and they are affordable and reliable. I always keep an extra set in case I need to replace a bearing.

These are going to work just fine. Honestly unless you are speed skating or something like that then these will perform well. Indoor or out, these will take everything you can dish out and keep coming back for more. I'm strange and like to mix it up...would ya look at that? Just look at the inside (red seal) those are ABEC 9 bearings.(I put the Rollerbones on the outside) If you are looking to go faster get ceramic bearings(2x$) but if you just need something that works and will do it day in and day out.... These are the standard by wich all others are measured. A bit overpriced? Perhaps, but you get what you pay for. These are not the best but they are close and they won't cost an arm and a leg.... A set of ABEC 9's are less expensive and work just as well.... ABEC 11's ? some companies marketing department know there are suckers born every minute... Don't be a sucker go with what works and has been tested over time. These bearings are what you should get.

Took a few seconds to install, very high spin ability. All were in tact and lubricated well. Take a bit of getting used to if you had beginner skates and wheels like me. But I just got them so practice will make perfect.Would definitely recommend

These are by far the best entry level bearings for the money. Keep them clean and lubed and they will last a long time.