GSCIT Club Black Edge Banding, 3/4 inch x 25ft Melamine Edge Banding with Hot Melt Adhesive Pre-glued Edge Banding Flexible Edging for Plywood Cabinet Furniture

I used this product in natural walnut to cover picture frames. I love the realistic grain and color. I wish they made a Sonoma or toasted oak color as I'd buy it in a heartbeat as it would make another project of mine so much easier.The product is sticky, but, depending on surface to which it is applied and how much you press it on, can be repositioned. I did not have any issue with glue oozing out as another reviewer noted. I loved that it has some stiffness as it made placement and precise cuts that much easier. I've worked with wallpaper, contact paper, vinyl wrap, and wood veneer and this was hands down the easiest product for me to apply. I had no issues with ripping but I have worked with some very finicky products previously and so I had a sense of how much this type of material can be stressed. Once I smoothed it all on, I had no bubbles or lifting. Adhesion was great for my application.

Cuts to size easily with scissors. Used a small 1 inch piece to hold one of my glass French Doors to my shower closed while showering to keep water inside shower and not on my new laminate plank floors. Otherwise gravity made that one shower door slip forward about an inch flooding my bathroom floor. Stays stuck in place and keeps Door from falling forward. Solved my problem.

Make sure the surface you are attaching this to is absolutely clean and free of grease and dirt. I cleaned surfaces on RV panels and one strip of tape keeps falling off. The others are still in place and holding well.

Easy to work with and looks amazing. No one would know it’s tape. I wanted to change my picture frame gallery wall without breaking the bank and this did the trick. 10/10 would definitely buy again

Good stick, but Very Stiff and non malleable. If you cut it to make a tab, it will break.

As a veneer, the material is plenty thick and substantial. It has somewhat limited ductility. It could probably be wrapped around a 1" dowel (your thumb), but much smaller than that and it will fracture. I think this would very rarely be an issue, but it means you cannot wrap it around a sharp edge of a cabinet. There is no guidance from the manufacturer about the acceptable temperature to set the iron. One reviewer was concerned that the banding could melt if the iron were set too high. However, Melamine is a thermoset, meaning it will not melt. It will decompose at about 650°F. It is also very resistant to ignition, and its ignition temperature is greater than 930°F. A typical electric iron will reach a temperature not greater than 450°F, so you do not need to worry about melting, or igniting the material. No need to put a layer of cloth between the banding and the iron. I don't know the melting point of the adhesive. Standard hot melt glue is dispensed at about 380°F. I also found the banding to be very forgiving, which I really appreciate. This means that if the banding is misplaced, you can simply reheat it, and move it, or remove it.I set the iron on cotton. The adhesive melted quickly, and set quickly enough that the band stayed in place. It was easy to trim with a razor blade. The stuff is really good, and easy to use.

I didn’t use it for the intended purpose. Used this to make a frame for my TV and it worked great for that! Great quality and looks good

this item is good and good quality i use it to trim out a bar top i would buy it a again