Neoprene Rubber Sheet Solid Rubber Strips Roll PadInsulation for Weather Stripping, Gasket, Shield, Costume, Seal, DIY (1/16" (.062") Thick, 12" Wide X 12" Long)

After a lot of searching and consideration we chose this product to attach to the bottom of our garage door. It boiled down to this or a relatively expensive option. Our garage is older and the cement is uneven, and or the door, and there are significant gaps on the outer ends where it meets the pavement/cement where rats and occasionally during very heavy storms, water has gotten in. This product ended up working better than hoped for. At first we weren't sure if the flap would lay properly or buckle but after getting it installed and trimmed (we carefully contour-trimmed where it meets the wood door frame- we found it closed down very well. Could probably do with a tiny bit more finessing on the trim-meet point (very slight buckling may be noted in photo) on the right but it's pretty good and performs as intended. We filled the other end where there was a gap beneath the trim, where someone must have cut out some rot long ago, with some foam pipe insulation. Not going to win better homes awards for appearance if that's a focus but functionality trumps glamor here. We contemplated a while on how large to go with and are very pleased with our ultimate decision which provides enough flap to ensure water etc is deflected. Didn't take too long or present too many challenges to install. Great solution and value as far as we're concerned. (Photos reveal a lot of detritus from recent rains).

If you need a pretty solid, thin piece of rubber, this is excellent. I bought two for use on the wings of my airplane, when I need a place to rest a fuel can or some tools. It’s plenty flexible while protecting the finish. And the price is reasonable.

Only needed a partial sheet and it worked as expected. Nice product to use.

Perfect for making a gasket for my Yamaha WaveRunner watertight bin. I have enough left to make one more if needed.

Very good quality, but the initial smell is quite strong; it smelled like a cigarette ashtray. I ended up putting it out in the sun, unwound, for two days (80 degrees daytime high) and then washed with soapy water; that brought the smell down significantly to a level that is quite tolerable.

Nice and pliable. I used it to replace the rubber hinge on my exmark mower dump bagger. Exmark wanted $150 for a replacement. I bought this for 50, cut it in two, punch some holes in it, had to rivet one section and bolt the other. It works perfect. When it wears out I have enough left over I can make another one. if i repurchase again i would go with the 1/8 "... would be easier to install and still heavy enough.

Worked really well for my application. The dust skirt on a new-to-me miter saw was in rough shape, and I was able to trace the exact shape on this sheet, cut, punch holes, and install on the saw. Neoprene rubber is the right choice, more abrasion and tear-resistance, and this is not a high temp application. The 12x12 was a great value and I have leftover for other projects.

It is as described. Good quality Neoprene.

Satisfecho con el producto

Works well on snowmobile tunnel to protect it from storage bag!

I made a kitchen cabinet without thinking much and later on decided to put Ikea drawers. After ordering and trying the drawers I realized it didn't fit well. It turned out that my cabinet was 1/4" wider than regular Ikea cabinets. So I decided to use this as shims. It worked perfectly and now I have working drawers. Thank you!

Hubby says it works great

Ok