105 Degree Right Angle Drill Attachment, 1/4 Inch Hex

This device managed both to drill holes and screw in an awkward position and with quite tough wood. I found for the most difficult part, I had to use a spanner to grip the right-angle adapter tightly, else it would (not surprisingly) spin around. However this worked well, and I assume the internal gearing in this is of high quality because it happily survived a lot of drilling and screwing.

I used this with a drill to disassemble the glovebox in my jaguar xe - it did work, but it was not the easiest/most intuitive experience so still much better to have a dedicated tool. The build quality is not bad (metal construction), but tolerances are a bit loose. All in all, it accomplishes what promises and for a cheap price.

Very good little tool to have

I used this to rebuild tyre walls at our race circuit. It's extremely handy for getting into awkward places, it does need a hand on it/rest it against the job to keep the whole tool from rotating. It's smaller than a cordless drill chuck, which is brilliant. However, it is made from very lightweight materials and the price reflects this. It lasted one day, around 100 uses, and then the bearing carrier and retainer fell out and it was renderer immediately useless. Therefore it is designed for infrequent use only.

This works a treat! all them hard to do angles are now irrelevent and it's way...WAY better than using one of them snakes

Mechanism is very rough and needed a lot of lubrication. Then the magnet fell out before I could even use it in anger.

Haven’t used it yet but I looks and feels great

Very small, perfect for those awkward jobs.

Helt OK som gör sitt jobb.

Tolles Teil, sehr praktisch!

Praktisch bei wenig Platz

Sehr praktischer Artikel für Heimwerker

Alle gut für enge Sachen ok man muss aber sehr festhalten