iBrightstar 50W 6ohm Load Resistors for Fix LED Bulb Fast Hyper Flash Turn Signal Blink Error Code

Was easy to install and stopped the hyper flash on my rear turn signals.

Worked perfect for aftermarket headlights

The connectors supplied with these resistors did not cut thru the wire insulation of 20 gauge auto wire. Please do not assume that the connections are good. Other than this issue, the resistors work good.

In order to install on my Audi A4, I had to remove the rear light module and use an ohmmeter to find out which pin corresponded to the backup bulb. The plastic clips that came with the resistors didn't work, so I had to cut the wires (blue/red for power to the backup lights, brown for ground), strip them, and splice in the leads to the load resistors. I used heat-shrink tubing to ensure the splices held. Re-installed the light modules, worked great - no more warnings that the rear bulbs are burned out. Took about an hour for the first one, 10 minutes for the second.

Easy to use! Just followed a few videos online, did what they said and now I don't have the annoying fast blink on my turn signals after installing LED lights.

One of them went out after 4 months. The other still works fine. Roll the dice on these.

Worked as it should

So on my original order one of the resisters was bad. But they replaced it for free quickly, next day in fact. I like that instructions for it are included on the page.

They are reliable so far.

Un buen producto y muy eficas funciona muy bien

Work well has fixed my problem

Simple to install.

Does the job. Wish the wires were a little longer though