Cast Iron Clean-Out Door, 8 by 8-Inch,Black

You will need a level, Phillips screw driver , sds hammer drill with a 6 +inch masonry drill bit and a 3/4 inch sds chisel. And a sealer . There are screws on the inside that you tighten to secure it. They wedge against the brick . My only complaint is give us a full size template.

I didn’t like long sticking screws inside the door that hold door in place. I had to drill holes in the corners and used concrete screws to securely mount the door. Some furnace caulking around the door and silicone tape made door air tight.

Nice metal!, Work great, the door is a little loose, but work great

Replaced a 1946 Portland Stove Castings #79 clean out door that rotted out finally. At 70 years it didn't owe me anything. The issue was that the old door was 7x9 and this is 8x8 but it did fit with a minor trim of some mortar in one corner. Had to reverse the screws so they push toward the outside but other than that 100% as expected. Nice finish and like I said really heavyweight.

Worked on what we needed it dor

Installation was fine. I'm concerned about the approach of using a screw to latch the door as I expect that will rust and become a problem down the road, but after 6-8 months so far it is still able to be removed. I am disappointed however that the paint/coating isn't better, it is rusting significantly after 6-8 months. Overall a decent product, but wish the design/quality were a little better.

This replacement by far exceeds the current one which is thin tin and rotted at the bottom. The current one is 30 years old, so it served its purpose.

very well made. Strong material. Beautiful look.