For LS Intake Manifold Compatible with LS1 LS2 LS6 of cathedral port heads with Drive by Cable Throttle Body Compatible with Chevy Cadillac Pontiac Aluminum (102mm)

Awesome product makes the engine look aggressive. Exceptional seller!

Easy to install don’t forget the adaptor if you have a three bolt throttle body

So the intake looks amazing. However. It does not fit truck injectors at all. I had to put ev1 (ls1) injectors I had laying around in it. Thank goodness I had those laying around. No matter what I do the passenger side fuel rail leaks like bad. Spues fuel from top and bottom of fuel rail. The driver side was fine. Except. I had to modify the brackets that hold the fuel rail to the manifold. When I put the brackets on and tightened them up it would just pull the fuel injectors out of the manifold cups. So I modified those. Now no matter what I do the passenger side fuel rail leaks fuel from top to bottom. This intake is cheap for a reason. My brother has one and his works. Just luck of f the draw I guess.

Looks amazing on my husband's box chevy

I read the reviews before I bought this knowing I would have to make some modifications and knew I had the skills to do it. That being said, I was happy with this intake manifold for the price saving me nearly $600 compared to a Holley and still got the look I wanted! These are the things you have to keep in mind if you purchase this product: 1.) if you have a drive by cable throttle body and intend to use it, you will have to fabricate a bracket to hold it or find one online that bolts onto the tb. 2.) the fuel rail brackets are too long and need to be trimmed and holes re-drilled to fit the short style injectors that the trucks use. 3.) the fuel rail crossover line interferes with the alternator so you will have to get creative and either a.) modify/trim some plastic off your alternator or b.) do what I did and route the fuel crossover from the backside of one fuel rail under the intake manifold to the front of the other fuel rail. (This requires more braided fuel line) Hope this makes sense!

Love it

Again, Awesome intake. Be very careful installing the injector, you will cut the o-rings. The fuel rails could stand to be tapered out just a little, it would make the job easier. And the hardware is a little short if you are using the drive by cable bracket.

Intake itself is great, looks great, ant went in without problem, the vacuum port attachments are noticeably cheap and 1 stripped out on me. The throttle body has constantly thrown codes for tps since installed, other than that it has been good so far

Love the look different design for long injectors not sure Shortys but with a little bit of modification, you can make it work

Worst product I’ve ever purchased, holes are not machined properly, neither are the fuel rail , brackets for fuel does not mount properly and pushes fuel rail out so injectors don’t seal right, Caused my project to go up flames and seconds from burning down my newly built shop and my classic project ,