Dongar Dashcam Integrator (10-pin Type B). Compatible with Select Toyota, Lexus, Subaru Models. Power Adapter Connects to Rearview Mirror, Built-in USB-C

This is such a great product used this on my wolfbox tri pro rear view mirror. Having this was a breeze on installing it on a Toyota 4Runner. This is such a well thought out product, I had the hardwire kit from Wolfbox first before installing this but this makes all the difference knowing that I’m not using an add a fuse on my fuse box. The fit was perfect fit the original connector from my rear view mirror with no problems. Works flawlessly when turning the ignition on and the rear view mirror turns on. The use of this product was very easy and it’s a plug and play harness. Will definitely solve any issues with installers that are not that mechanically inclined as this product is very easy to install.

This doohickey was very easy to install into my auto dimming mirror. I just looked online to make sure I was plugging into the mirror and not my car’s sensors. The hardest part was taking off the cover to access the connections themselves. I love not having hanging wires. Yay Dongar!

Easy 10-Minute Installation I’m very happy with how easy this dash cam was to install. I have the rearview mirror camera setup, and the entire installation took about 10 minutes. I removed the center plastic cover and the large wrap-around cover, disconnected the mirror connector, and plugged it into the Dongar cable. I then connected the Dongar cable to the camera port, plugged the power into the USB-C adapter, and connected the USB-C cable to the dash cam. That’s it! The dash cam fired right up and worked perfectly. No complicated wiring, no mess, and no need to run cables all over the vehicle. If you’re looking for a dash cam that’s easy to install, I definitely recommend this one.

this worked out perfectly. Installed a Viofo dual dash cam in a 2026 Tacoma. It fits perfectly and the install is very neat - no wires running to the dash. I had a few questions on my specific car and compatibility so contacted CS by email. They responded immediately with a detailed answer - super helpful. Would highly recommend.

Put in my 2026 4runner. Easy to install and works perfectly. Highly recommended to not have to run a long cable.

I love a seamless look on and this did the job on my 2020 Subaru ascent. I was able to hide the USB-C wire under the cover of the rear mirror display and that was the hardest part. After that it was plug and play. A 12 inch USB-C wire is recommended. The one that comes with the Dongar may be to short for some applications. I used the REDTIGER F7NP 4K Dash Cam for my set up. So far so good.

I was really hesitant about this, but I went ahead and took the plunge. I have a 2025 RX 350h that this is installed in. The install was very easy. The hardest part was getting the plastic covers on/off the rearview mirror. There's not a ton of room behind the mirror. The Lexus cover clips are also an issue when you're trying to reassemble anything. Definitely find a Lexus install video because there are some tricky parts. I have a REDTIGER 4K Dash Cam Front Rear, STARVIS 2 Sensor hooked up to it and there seems to be no issues with the car electronic or the dash cam. The power cord section is plenty long to reach most center window placements. The connector definitely fits the Lexus RX 350. I spent a lot of time trying to make sure this was the right connector for my car without have to pull all molding off to inspect the connector in the car. I would definitely buy this again and have recommended it to friends.

Fits my 2026 Toyota 4Runner TRD Off-Road Premium so it is compatible. Installation requires popping off the cover, which is easy enough. My main complaint is the double-sided tape included with it just wasn't sticky enough to adhere properly. I ended up swapping in some 3M Heavy Duty mounting tape I had on hand, and it's held strong ever since (if you're having adhesion issues, replacing the tape is a solid fix). Running the cable takes a bit of trial and error since there are a few routes you can take that are pretty tight tolerances, but once you find the right path it fits nicely. Overall, it does the job powering my dashcam with a clean setup.

Make sure you get the correct Dongar for your vehicle - then it is al so simple, quick and tidy. Great Device!! Totally removes the hassle of feeding wires from the camera to some remote power source.

Bought for use with a Lexus NX350H, the hardest bit was removing the plastic panels around the mirror surround. The power adapter is a plug and play device and fits into the mirror power plug. It gives a very neat installation. Please note it does not include a trim removal device (I used one supplied with the dash cam).

Just installed this in my 2026 Toyota Tacoma Limited Hybrid. Installation was super easy and worked like a charm with my Vantrue dashcam. Would recommend.

Easy fit no problem with it working and save me money.

You're basically paying 50$ for a cable, but a very useful one at that. Was able to reduce a lot of the wiring i needed for my dashcam so it was definitely worth it