Smittybilt 76892 XRC Atlas Front Bumper for 2007-2018 Jeep Wrangler JK 2/4-Door

Replaced factory bumper . Pretty heavy . Two person job . Directions are minimal however the look is great ! Added a winch and love th look. Left off th silver pieces !

So if you are looking for a bumper that will completely destroy anything it hits. Well here you go. This thing is super heavy and seriously stout. I put it on my 2013 Jeep JK Wrangler. It takes two people for sure. We ended up taking it off and putting right back on because all of the bolts and nuts that have to be tightened down. I would almost suggest assembling it before you mount it. It would off cut install time by a lot. But it’s on there now. So install is the hardest thing with this bumper. Also I did get the rear bumper as well that matches this front bumper. So it did end up dropping my fuel mpg a little. Not much. I went from 16 to 13 mpg. But hey it’s a Jeep who cares! Oh and side note. There are a ton of extra parts with this. Every Smittybilt product I’ve ever bought always puts way to much in the box.

I was unable to install due to defective hardware in the package and it's been an ongoing nightmare to return. Do not purchase from 4Wheel Drive Hardware ad they will ghost you and the A to Z process for Amazon is effectively broken for bulky items.Note that for a 2012 or newer JK, be prepared to cut your frame and also relocate the brake vacuum pump if you want to use the recessed winch plate. This should be made more apparent in the advertising for this product or I would've bought a different bumper.

Great looking bumper easy install! The only issue was that they didn't take into consideration on the drivers side there is a component that is attached to the frame that made the frame mounts for the bumper not quite fit. I just had to drill it out a bit and then it was fine. The fog lights fit right into the bumper. I just had to unwrap some of covering and move the wiring over.

Very easy to install - right up until you get to the armor that bolts under the bumper. The side holes neither come close enough to the side of the bumper to bolt them in, nor do they both line up. The capture bolts are also poorly done; the 'clip' that would hold them to the bumper isn't deep enough so they pop out with the slightest provocation - like when you're trying to start the bolts threads into the bolt. A quick call to 'support' was met with a clueless response with no suggestions or offer to replace the ill-fitting part. Smittybilt USED to represent quality products. Not so much anymore. The bumper looks nice, but the execution and support are lacking.

I love it! It’s a great addition to my front end. The only reason I didn’t give 5 stars was because on each side on the top it was scraped and we had to paint it. It also has a hole in the front side.

Outstanding product, easy to install and looks great

Awesome