Blinker Genie 2 - for AUTOMOBILES. Converts 2-wire LED to 3-wire for Run AND Turn!

Got a set of these to make my mirror's lights work both as run lights and turn signals. The difficult part was to source the cables from each turn signal into the circuit, but installing this item itself is quite easy. Using it with 3 LEDs on each side plus a LED-friendly blinker relay and works awesome!

I had running lights along my bus that I wanted to turn into turn signals and running lights. After searching everywhere I came across this. The instructions were very clear and straight forward. It works great after hooking it up. Exactly what I wanted. Amazing product!

Hope this works I’m adding 2 wires together to make it not hyper flash

Blinker Genie converted my 2-wire LED turn signals to 3-wire functionality. Easy to install. Works great.

It works as advertised. It would have been fast shipping but the post office messed up not custom led. First class Mail is standard with priority mail the expedited shipping I believe.

Very nice solution to an odd problem. Used with 2.5 inch led beehive light on old truck for running lamp and blinker.

I'll begin by saying i have worked with 12v wiring since i was about 16 years old. Im now 47. Ive installed lights, car stereos, police equipment, cameras, other electronic components, etc. for years and years. I have a fairly decent grasp of 12v circuitry.I was recently tasked with wiring a UTV with turn signals, a fairly simple project ive done successfully a few times now. The owner of the vehicle wanted to wire a signal into the existing LED tail light/brake light assembly. Ive done this before and it can be pretty detailed. The description of this product sounded like what i was needing to accomplish this and much more simple than what ive done in the past. The product arrived quickly and i read the accompanying instructions, as i always do. Seemed pretty straight forward. I identified the appropriate wires on the UTV using a multimeter along with wiring schematics from the manufacturer. I wired this product in according to the instructions. The instant i turned the key of the UTV to the position where tail lights are activated, the two Blinker Genies popped loudly and smoke began rolling from the rear of the UTV. I removed the Blinker Genies and tested the UTVs lights. All working appropriately. I resorted to the old method of wiring the signals, which worked just fine.These may work in certain applications, but they did not work for this particular project. The shortcut i was hoping for ended up costing me more time and money.

I installed this on a 2011 Jeep Wrangler in order to turn the front side marker lights into running lights/ blinkers. I spliced in the wires as instructed and they perform as described. The side marker lights blink with the front blinkers. others tie the side marker light into the front blinker’s ground, that makes the side marker light & front blinker alternate. I’m pretty happy with this solution. it adds a bit of bulk, but i was able to zip tie the excess wires to frame behind the grill.