Aquarium Floating Betta Fish Skins, Betta or Shrimp Feeder, Cave and Hammock, Small Fish Feeding Rings, Aquarium Hiding Feeding Decorative Accessories (Translucent Color)

4.5 stars, but I’ll round it up to a 5! This is great, bigger than I expected, and looks awesome in my 5 gallon betta tank! My betta immediately went inside and I’ve seen him resting in it several times already. I also now use this as my feeding space as I have floating plants on the water surface. My one complaint is that there was a rough edge at the bottom of the hideaway entrance. I was worried about it snagging onto my betta’s fins so I had to “sand it down” with a nail file.

Our Betta went directly into it as soon as it was placed in aquarium and hung out for a good while. Was nice to putting floating food into as it stayed within and floating around tank. I’m going to make this his feeding spot from now on. Great looking product too. I like the way the mesh looks. Cheers!

I love this!!! It’s a good size for a 29 gallon. I got the large one. It’s plenty of space for my betta. It’s 3D printed I believe. He went right inside. One thing about it tho it needed sanded down in the inside a little bit cause there was some sharp points. I just put rocks in the cover it. But I do love this for my boy.

The media could not be loaded. It’s awesome, fish grew to love it quickly, sturdy and floats well, fits nice, no suction or tugs on anything, stops any big currents from filtration systems and he loves it. Cleans real quick, and it looks ok. Drop in and forget and feed through the top. Easy.

My betta loves it. It comes a bit rough with sharp edges where it was removed from the printer, but I fixed that in 5 minutes with some sandpaper. Definitely worth it. Good at containing floating plants to provide a nice cover from the lights.

My Betta loved this so much that I bought him another one :-) Like others have commented, I did take a low-grit sandpaper to the inside for about 30 seconds. great quality!!

My betta loves this thing. It was dirty so I took it out to clean it and realized that it’s falling apart and the inside is very rough. Its hard to tell in the picture but all if the little straight bits are breaking and leaving sharp/poking edges It appears to be 3-d printed, which cool- but it’s breaking down.. Needless to say it’s not going back in. I will be replacing it.

My betta loves going inside this hangout spot. It helps with feeding because it protects the food from being scattered by the current from the filter. It moves around to different areas so it gives him a change of scenery.