Alphacool NexXxoS XT45 Full Copper X-Flow 360mm Radiator (14235)

The radiator came with a good finish and was surprisingly clean inside. I ran a loop of water through it on an aquarium pump with a fine filter for a few hours and very little debris was left in the filter. I will say the 45mm rad is overkill for a single component and you may want to consider a 25mm or 30mm rad for such an application because you will definitely notice the bulk of those extra 15-20mm. Alphacool did a great job with this radiator and the cross flow feature is really nice for running a loop without cluttering the case with unnecessary tubing. I would not hesitate to go with Alphacool again for any radiators or other water cooling products I may need in the future.

Absolutely great cooling capability, I purchased this one along with the same model with the regular ports to put into the new lian li evo case. In total the case has 3 360mm rads. I have a 2080ti and the Temps for the gpu are 30c at idle/ cpu idle 29c. While gaming 46c gpu and 44c cpu. Only gripe is like others have mentioned the plug. I did purchase slimmer plugs but they still raise the radiator more on the plug corner, my fix was simple, I used small spacers in between the radiator and the case on all holes til the plug cleared and all corners of radiator were even.

I have a XT45 360 and a 240 in a Lian Li PC-O11 Dynamic XL as well as an ST30 360. They work great and I love the cross flow allowing me to spread my tubes out. However, you must be aware of the radiator cap. It extends lower than the rad itself, forcing you to mount the rad on fans, not flush against the chassis. My top and bottom rads are both mounted on the fans (pic1) so its not an issue. The ST360 was mounted against the back and as you can see (pic2) it only just fit with the cap being flush up against the frame. If you're able to mount these rads so that the caps don't interfere, they are absolutely fantastic rads.

Well built, Hardly any debris inside when I flushed. This thing is thick with fans so make sure you have the room. Still building so i cant comment on the effectiveness yet but other more scientific people have already done radiator breakdowns and this one ranks high. Also easy to paint and customize. The 6 ports lets you figure out the best config and add things like water temp sensors, or just easy fill and drains. . Love it.

The X-flow design helped me minimize the hard lines in my case. Also the fittings on all three sides of the end caps give nice options, allowed me to fill from the top of the case. Very nice quality

Rad leaks air pressure test