10" Heavy Duty 4.10/3.50-4 Tire - Dolly Wheels and Hand Truck Wheels Replacement - 4.10 3.50-4 Tire and Wheel for Gorilla Cart, Generator, Lawn Mower, Garden Wagon. 5/8" Axle Borehole (2 Pack) Ram-Pro

They were the right tires for the dolley

Works as advertised

I installed these six months ago on my wife’s Gorilla Cart that she uses to haul four watering cans. So she pulls around about 40 pounds, two to three times a week during the growing season. They were a great fit. So far, they have held up well. They hold air just fine, I may have topped the air off once or twice over the six months.

Very good

Needed these tires for replacement. Very satisfied with performance.

I bought these to replace the wheels on my Craftsman Professional 1.6hp, 175psi Air Compressor. I have had them for a few weeks and I was immediately suspicious due to the price. But, the reviews were good so I went against my better judgement. The first thing I noticed was that the "axle shaft" or the bushing housing which the bolt (axle) goes though to mount these wheels to the frame of the device they're being mounted to was significantly smaller than those that came off and the ones I looked at at TSC, Northern Tool, Harbor Freight, or Ace Hardware. The tires were narrower than most of the others. They are really skinny compared to the ones that were original. I have seen much wider tires on small 250lb hand trucks. Even the tires on my Igloo ATC cooler are heavier duty than these were. But, giving the benefit of the doubt, I tried to use them anyway thinking that the product description portrays them as much more rugged and utilitarian than they seem. BIG MISTAKE! The 2nd time out of my building door the rim warped. Apparently, not only are they near paper thin 2pc rims but the weld on the bushing is very weak.In short, if you are planning to use these on something small and weak which will not be carrying a load, go for it. For anything heavy, like a generator, air compressor, or loaded wagon, buy local and return if necessary.

I needed to replace a tire tube on my dolly and decided to replace both wheels and tires instead. I was surprised by the quality of the tires and wheels, and they were an easy swap on my dolly. I do recommend getting new push cap axle locks. I inflated the pressure marked on the tires and put the dolly to use in our house moving. The tires held up under some extreme loads that were past the recommended loads on the tires. Good product for the price.

I had an old dolly with one tire rotted. I decided to buy new tires as long as they seemed simple to swap. It was a breeze. I used the same pin, and everything was installed in less than 5 minutes.