Opella 90150.31 Kitchen Sink Hole Cover, Euro White

I tried "euro white" and "polar white" to match my Kohler porcelain sink when we replaced a three point faucet with an integrated unit, leaving two holes. Euro white a just-off-white and a good match for our sink. These plastic units are much less expensive than Kohler's porcelain covers, and look fine. Basically, you put the plug in the hole, get under the sink and tighten the plastic nut on the bottom until the cap and the washer on the top are tight. The washer is rubber and prevents leaks.I briefly looked into the alternative - a stainless steel "escutcheon" that would cover the entire shelf along the back of the sink, but (1) I wasn't confident that I could get one that would be a good fit for my sink, and (2) you have to put that on before you put your faucet in.

Looks nice on the white enamel sink. Expect some gymnastics to reach up under the sink to install these. It can be done with one person (I did), but is easier with two, one under sink and one to "center" the piece on top. Once installed they have not moved. I use a toothbrush or bristle brush to clean the little bit of dirt which accumulates around the edge of each cover (I have two). I have not noticed any water drops under the sink so I think they are keeping the water out.

Not a lot to say about a sink hole cover. However as I learned there are a bunch of different ones on the market. most are cheap plastic. The metal ones are, well they go with stainless sinks. My white sink needed a white cover. This particular one is heavy duty all heavy duty plastic, is not likely to break like the one I bought at big box 6 months ago and disintegrated. Polar white matches Kohler white sinks by the way.

Perfect. Just what I wanted to cover holes in my sink left from removing extra dispensers. Replaces simple covers that rusted away and looked nasty. These are very sturdy, match the sink color well enough, and hopefully will last a long time. I expect the solid color to help with appearance should these become scratched. A great solution!

Ordered the polar white, matched perfect with a Kohler white sink and faucet. I was worried of the color because there are two white covers listed. I like the plastic for this application because the old metal one got rusty around the edge and was hard to remove because it was rusted on. It helped to have a second person to center the cover and seal washer on top while installing because the threaded part is smaller diameter than the hole in the sink but it stays in place once tightened.

This item is just as advertised. Installs fairly easy and color matches my sink acceptably. A little pricey but probably got what I paid for, seems to be quality materials.

I had a hole in my sink that I could not find a piece to fit over. This is a great product. Because it has a screw on back and a rubber ring it goes on tight and no water gets through. It works great in my 1940's farmhouse sink.

Works perfectly, good quality and color, and includes rubber gasket for good sealing. It doesn't exactly match my Kohler faucet but it's impossible to tell unless you're looking for it. No reason to pay more for.

as described