CAMELBAKEddy+ Cap and Straw, Black Bottle - 100 White/Natural, N

Fits the Camelbak Multibev perfectly,with no leaks. Good design which has a handle built in.

Used to replace my eddy bottle top and straw and it’s perfect. Super great quality. Perfect replacement.

I purchased this bottle lid as a replacement for my older water bottle and was immediately impressed by its clarity and ease of fit.Not only is it visibly much clearer than its predecessor, but it also makes it less likely to leak. It comes with a straw which is a bit long; however, trimming it to size was hassle-free using just a pair of scissors after a quick measurement against my existing straw.Despite the leakproof improvements, it does inherit a minor flaw from the old design—gunk accumulation in the lid’s bendy section. I managed to clean most of it with a tiny bottle brush, but your mileage might vary. All in all, it’s a solid purchase with just a small room for improvement.

The pleasure of using original replacents, fits perfect.

Project Progress ReportProject: Bottle RestorationOverview:The Bottle Restoration project aims to restore damaged bottles to their original condition. The project involves the purchase of a restoration kit that will be used to repair the damaged bottles.Project Status:The project is progressing well. We have purchased the restoration kit, which has proven to be a good buy to get our bottles back up and working. The kit includes all the necessary tools and materials needed to fix the damaged bottles. We have tested the kit on a few bottles, and the results have been impressive.Challenges Faced:We encountered a few challenges during the project. Firstly, it was difficult to find a restoration kit that was suitable for the type of bottles we have. However, after some research, we found a kit that met our requirements. Secondly, the restoration process was time-consuming, and we had to ensure that we followed the instructions carefully to achieve the desired results.Next Steps:The next step is to complete the restoration process for all the damaged bottles. We have scheduled a timeline for completing the restoration process, which we believe is reasonable. We will also conduct a quality check on all the restored bottles to ensure that they meet our standards.Conclusion:The Bottle Restoration project is progressing well, and we are confident that we will achieve our objectives within the set timeline. The restoration kit we purchased has proven to be a good buy to get our bottles back up and working. We will continue to monitor the progress of the project and communicate any updates to the relevant stakeholders.

All in good condition, thank you

I was a bit concerned that the straw was too short. However it appears to be ok and required no cutting to fit. I would be wary of this cap fitting the larger bottles as I do not think the straw will be long enough for them..

Good replacement part,